AGFA Printer manual Cover Open Sensor

Page 6

:ANAPURNA L/XL

OPERATOR MANUAL

COVER “OPEN” SENSOR

This engine is equipped with a “safety sensor” on the Front and Rear cover. Carrige movement and printing can only be done with covers closed.

.

1.When carriage is waiting: (Purge or Home)

When a cover is “open”, you will see the “door open error” on the screen, and the carriage will not move to Home or Purge if requested.

2.During printing:

When you open the cover at this stage, the PRINT will be CANCELLED and the UV lamp shutter will be closed automatically.

OPENING THE COVER DURING PRINTING, WILL RESULT IN A CANCELLED PRINT !

ONLY OPEN THE DOOR IN EMERGENCY SITUATIONS !

AB]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]6]8/09/2006]

Image 6

Contents Anapurna L/XL Table of Contents Safety Instructions Printer Overview and Features System DimensionsFront view, parts & locations Rear view, parts & locations Cover Open Sensor Head Carriage view, parts Signal tower Head technology Color SequenceColor gamut Anapurna UV Curable InkGeneral information PackingAuto ink supply Ink CircuitMain ink tanks Sub Ink TankRead out How to make changes 2-Way valves Printing heads Ink supply by means of negative pressureEncoder Test can be found in the Test menu Ink Refill System what can go wrong… Waste TankLamp Type Cure Default, Set or Both Curing setup and sequencesSettings in software UV Curing SystemBy default, Full power should be used whenever possible Uni- and Bi-directional printingPrinting Table Belt Tension controlMaintenance Replacement of Conveyor beltMaintenance Daily Maintenance Nozzle check/purgeLittle purge Cleaning the failing heads Weekly Maintenance Engine Storage AT the END of the WeekLong Stand Still Engine is NOW Ready for a Long Stand StillEngine is NOW Ready to Print Again Media Setup Roll to RollAuto Feed System Take-Up Motor Box Rigid Media Rigid Support tablesAB298/09/2006 Automatic Head Base Height Setup Head Base Height ControlMm Gap Display Printing Progress Anapurna Control ProgramControl Program Menu Set Top forward and Left MarginSetup Parameter Menu Good AB358/09/2006 AB368/09/2006 Test Menu To end this test, select Reset Test in the same menu, Carriage will move slowly back to the Home positionPreparing the Anapurna Printing an imagePreparing an image Carriage must be moved to the home position firstPrinting the image Cancel a print While printing, press S and Y, the print is then cancelledPurge function on the printing Media corners lift a bit up rigid media Tips & TricksPrinting on heat sensitive media Image size/border Wasatch Rip