AGFA Printer manual AB298/09/2006

:ANAPURNA L/XL OPERATOR MANUAL

Important

When printing on heat sensitive media, always make sure the right

UV lamp is going passed the media, on the point of returning.

(otherwise there will be more heat at the left side of the media,

which can cause media cockling or produce a yellowish shine on some media)

This can be arranged on the Rip level by entering a white space, and/or on

the engine, by changing the Left Margin distance.

9.2.3. Vacuum

With rigid media, the vacuum settings must be chosen according the covered area on the conveyor belt. When printing on two rigid media, activate both the vacuum tables (1&2). (more info: see chapter 7.1)

9.3. Media Roller Bars

The engine has got one roller bar on the front, and one on the back.

They are located underneath the front- and back-covers. These bars will help to keep the media flat while it’s been transported on the conveyor belt.

It can be used on Roll media, as well as on rigid media.

You can lower the bars, by switching the “FRONT” or “REAR” buttons.

When you’ve taken out a bar, and want to re-insert it:

Make sure both side’s are positioned as high as possible into the left

and right unit, then gently lower both sides, the bar must stay completely horizontal for best use.

AB]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]29]8/09/2006]