Toshiba B-SX5T-TS22-QM-R, BSX5TTS25QMR, BSX5TTS22QMR, B-SX5T-TS25-QM-R manual Print Test, Adjustment

2. PRINTER SETUP

ENGLISH VERSION EO1-33059

2.11 Print Test

2.11 Print Test

After your operating environment has been set, perform a print test.

1.Perform a print test by using the Printer Driver or an Issue Command.

The printer driver’s Properties screen allows you to set the communication conditions, media size, and other printing conditions in accordance with your operating environment. For details, refer to the Help for the Windows Printer Drivers screen.

Example: Stock tab display of the Printer Driver’s Properties Screen

Print Method

Sensor

Label Gap

Issue Mode

Cut

Print Speed

Fine Adjustment

Print Method:	Direct thermal or thermal transfer is selectable.
Sensor:	Media sensor type is selectable.
Issue Mode:	Batch or strip is selectable.
Cut:	Whether to use the cutter or not is selectable.
Fine Adjustment:	Adjustment values for the feed amount, cut/strip
	position, etc. can be set.

2.Confirm the print test result.

•When a print start position, cut/strip position, or print tone needs to be adjusted: ⇒ Section 2.12 Position and Print Tone Fine

Adjustment

•When pre-printed media is used, and if a print start position is not properly detected: ⇒ Section 2.13 Threshold Setting

E2-55