1. Introduction and Installation
2Pull the tension plate forward (1) and attach the paper tray cover (2), then push the tension plate back (3).
2
1
4
1.7 Paper stacker
Line up the slots (1) in the paper stacker with the pegs (2) on the bottom of the unit, then insert the two tabs of the paper stacker into the slots on the unit (3).
2
3
3
Note:
LDo not place the unit in an area where the
paper tray may be obstructed (i.e., by a wall, etc.).
LKeep this surface (4) away from walls etc. more than 50 mm to let the unit cool down.
To remove the paper tray
Pull the paper tray forward in the direction of the arrow.
1
Note:
LDo not place the unit in an area where the paper stacker may be easily bumped into.
LDocument and recording paper will be ejected from the front of the unit. Do not place
anything in front of the unit.
LThe paper stacker can hold up to approximately 100 sheets of printed paper. Remove the printed paper before the paper stacker becomes full.
14