ADTRAN TA 544 Maint Port Menu, Password Protect, Instructions for Changing Passwords Step Action

Page 20

TA 544 User Manual/61200704L1-1A

Page 20 of 68

> Maint Port Menu

The TA 544’s VT 100 CRAFT port can be accessed via an RJ-48 located on the rear panel. The setup for these ports is under this menu.

Password Protect

When set to OFF, the maintenance port is not password protected. When ON (def), the TA 544 will prompt for a password upon startup.

Password

This is the text string that is used for comparison when password protecting the maintenance port. By default, no password is entered.

If you forget your password, type CHALLENGE in all capital letters. Call technical support and have the displayed CHALLENGE code ready.

The security level for the maintenance port is always set to 0. This gives full access to all menus.

Passwords are case-sensitive.

Instructions for Changing Passwords

Step

Action

1Select the PASSWORD field—a new PASSWORD field displays.

2Type the new password in the ENTER field.

3Type the new password again in the CONFIRM field.

The password can contain up to 12 alphanumeric characters. You can also use spaces and special characters in the password.

TA 544 User Manual

© 2001, ADTRAN, Inc.

Image 20

Contents 1200704L1 4200704L3 Trademarks To the Holder of the ManualSafety Instructions Limited Product Warranty International Contact Information USA2001, ADTRAN, Inc Customer Service, Product Support Information, and Training Presales Inquiries and Applications SupportPost-Sale Support Repair and ReturnTraining Training 800 615-1176, extContents 2001, ADTRAN, Inc Figures 2001, ADTRAN, Inc Firmware Updates Terminal MenuVoice Over DSL Application Unpack and Inspect the Unit Mount the UnitSystem Info Bootcode Revision Part NumberSerial Number Firmware RevisionSystem Config Operating ModeNetwork Timing Mode Telnet AccessSnmp Menu Maint Port Menu Password ProtectInstructions for Changing Passwords Step Action Network Time Upgrade Firmware System UtilityConfig Transfer Ping Configuring WAN Settings ATM ConfigDslam Type Layer One InterfaceATM Stats Data ScramblingAP Receive Cell Errors AP Rx CellsAP Rx OAM Cells AP Receive Cells DiscardedDSL Rate Config Configuring the Router Configuration GlobalUse this menu to enter static routes to other networks Bridge Security Ethernet Ethernet MenuMAC Address WAN This is the network mask used for this interface Use this menu to configure IP settings When set to Y ES, only IP RIP updates are sent All incoming packets from the WAN are not Configuring the Router Status SessionARP cache Bridge TableConfiguring the Router Logs Network Log WrapView ClearConfiguring Voice Support Config Call ControlConfiguring Voice Support Status Gateway StatsPVC Stats Voice StatsManaging the Modules Modules Modules TableMode Managing the Modules V.35 SetupConfiguration Following settings are used for FRF5 Following settings are used for FRF8 Appendix A. Specifications and Features Network InterfaceATM Support Isdn InterfacesSecurity Features PowerManagement Options Serial DataPress Enter until a menu appears Appendix B. Updating TA 544 Firmware using XmodemUpdating Firmware via a Forced Download Updating Firmware via the Console Menus 2001, ADTRAN, Inc Appendix C. Updating TA 544 Firmware using Tftp Message Meaning Message Meaning Enu Path Left Pane Status Bar Ode Avigation H elpWindow Pane Navigation Right Window Pane NotationAdditional Terminal Menu Window Features Navigating Using the Keyboard KeysSession Management Keystrokes Getting Help Application Diagram Voice Turn Up Step Action Appendix F. RFC1483 Quick Start IP Routing WAN Appendix G. RFC1483 Quick Start IP Routing with NAT OptionsAppendix H. RFC1483 Quick Start Bridging Bridging Step ActionAppendix I. PPPoA Quick Start Guide