ADTRAN TA 544 Configuring WAN Settings, Dslam Type, Layer One Interface, Layer Two Protocol

Page 25

TA 544 User Manual/61200704L1-1A

Page 25 of 68

# Transmits

Total packets sent (read only).

# Receives

Total packets received (read only).

%Loss

Percentage loss based on ping returned from host (read only).

Configuring WAN Settings

> DSLAM Type

Set this to the type of DSLAM the TA 544 will be connecting to.

> Layer One Interface

This is the physical layer protocol used to connect the DSLAM to the TA 544.

> Layer Two Protocol

This is the data link layer protocol used to connect the DSLAM to the TA 544.

> ATM Config

Use the WAN menu (Figure 6) to access the ATM CONFIG menu.

Training Mode

Figure 6. WAN Menu

© 2001, ADTRAN, Inc.

TA 544 User Manual

Image 25

Contents 1200704L1 4200704L3 To the Holder of the Manual TrademarksSafety Instructions Limited Product Warranty USA International Contact Information2001, ADTRAN, Inc Presales Inquiries and Applications Support Customer Service, Product Support Information, and TrainingPost-Sale Support Repair and ReturnTraining 800 615-1176, ext TrainingContents 2001, ADTRAN, Inc Figures 2001, ADTRAN, Inc Terminal Menu Firmware UpdatesVoice Over DSL Application Mount the Unit Unpack and Inspect the UnitSystem Info Part Number Bootcode RevisionSerial Number Firmware RevisionOperating Mode System ConfigNetwork Timing Mode Telnet AccessSnmp Menu Instructions for Changing Passwords Step Action Password ProtectMaint Port Menu Network Time System Utility Upgrade FirmwareConfig Transfer Ping ATM Config Configuring WAN SettingsDslam Type Layer One InterfaceData Scrambling ATM StatsAP Rx Cells AP Receive Cell ErrorsAP Rx OAM Cells AP Receive Cells DiscardedDSL Rate Config Global Configuring the Router ConfigurationUse this menu to enter static routes to other networks Bridge Security Ethernet Menu EthernetMAC Address WAN This is the network mask used for this interface Use this menu to configure IP settings When set to Y ES, only IP RIP updates are sent All incoming packets from the WAN are not Session Configuring the Router StatusARP cache Bridge TableConfiguring the Router Logs Wrap Network LogView ClearCall Control Configuring Voice Support ConfigGateway Stats Configuring Voice Support StatusPVC Stats Voice StatsModules Table Managing the Modules ModulesConfiguration Managing the Modules V.35 SetupMode Following settings are used for FRF5 Following settings are used for FRF8 Network Interface Appendix A. Specifications and FeaturesATM Support Isdn InterfacesPower Security FeaturesManagement Options Serial DataUpdating Firmware via a Forced Download Appendix B. Updating TA 544 Firmware using XmodemPress Enter until a menu appears Updating Firmware via the Console Menus 2001, ADTRAN, Inc Appendix C. Updating TA 544 Firmware using Tftp Message Meaning Message Meaning Status Bar Ode Avigation H elp Enu Path Left PaneRight Window Pane Notation Window Pane NavigationNavigating Using the Keyboard Keys Additional Terminal Menu Window FeaturesSession Management Keystrokes Getting Help Application Diagram Voice Turn Up Step Action Appendix F. RFC1483 Quick Start IP Routing WAN Options Appendix G. RFC1483 Quick Start IP Routing with NATBridging Step Action Appendix H. RFC1483 Quick Start BridgingAppendix I. PPPoA Quick Start Guide