ADTRAN TA 544 AP Rx Cells, AP Rx OAM Cells, AP Receive Cells Discarded, AP Receive Cell Errors

Page 27

TA 544 User Manual/61200704L1-1A

Page 27 of 68

Figure 8. ATM Stats Menu

AP: Tx Cells

This is the number of cells transmitted.

AP: Rx Cells

This is the number of cells received.

AP: Rx OAM Cells

This is the number of OAM cells received

AP: Receive Cells Discarded

This is the number of cells received and discarded. An incrementing count in this field could indicate a con- figuration problem with the ATM layer.

AP: Receive Cell Errors

This is the number of cells received with an HEC error.

AP: Sync

This indicates cell delineation at theATM layer.

AP: Out Of Cell Delineation

This indicates loss of cell delineation at theATM layer.

AAL5: Transmit Frames

This is the number of AAL5 frames transmitted.

AAL5: Receive Frames

This is the number of AAL5 frames received.

AAL5: Transmit Discarded Frames

This is the number of AAL5 frames discarded.

© 2001, ADTRAN, Inc.

TA 544 User Manual

Image 27
Contents 1200704L1 4200704L3 To the Holder of the Manual TrademarksSafety Instructions Limited Product Warranty USA International Contact Information2001, ADTRAN, Inc Repair and Return Customer Service, Product Support Information, and TrainingPresales Inquiries and Applications Support Post-Sale SupportTraining 800 615-1176, ext TrainingContents 2001, ADTRAN, Inc Figures 2001, ADTRAN, Inc Terminal Menu Firmware UpdatesVoice Over DSL Application Mount the Unit Unpack and Inspect the UnitSystem Info Firmware Revision Bootcode RevisionPart Number Serial NumberTelnet Access System ConfigOperating Mode Network Timing ModeSnmp Menu Password Protect Instructions for Changing Passwords Step ActionMaint Port Menu Network Time System Utility Upgrade FirmwareConfig Transfer Ping Layer One Interface Configuring WAN SettingsATM Config Dslam TypeData Scrambling ATM StatsAP Receive Cells Discarded AP Receive Cell ErrorsAP Rx Cells AP Rx OAM CellsDSL Rate Config Global Configuring the Router ConfigurationUse this menu to enter static routes to other networks Bridge Security Ethernet Menu EthernetMAC Address WAN This is the network mask used for this interface Use this menu to configure IP settings When set to Y ES, only IP RIP updates are sent All incoming packets from the WAN are not Bridge Table Configuring the Router StatusSession ARP cacheConfiguring the Router Logs Clear Network LogWrap ViewCall Control Configuring Voice Support ConfigVoice Stats Configuring Voice Support StatusGateway Stats PVC StatsModules Table Managing the Modules ModulesManaging the Modules V.35 Setup ConfigurationMode Following settings are used for FRF5 Following settings are used for FRF8 Isdn Interfaces Appendix A. Specifications and FeaturesNetwork Interface ATM SupportSerial Data Security FeaturesPower Management OptionsAppendix B. Updating TA 544 Firmware using Xmodem Updating Firmware via a Forced DownloadPress Enter until a menu appears Updating Firmware via the Console Menus 2001, ADTRAN, Inc Appendix C. Updating TA 544 Firmware using Tftp Message Meaning Message Meaning Status Bar Ode Avigation H elp Enu Path Left PaneRight Window Pane Notation Window Pane NavigationNavigating Using the Keyboard Keys Additional Terminal Menu Window FeaturesSession Management Keystrokes Getting Help Application Diagram Voice Turn Up Step Action Appendix F. RFC1483 Quick Start IP Routing WAN Options Appendix G. RFC1483 Quick Start IP Routing with NATBridging Step Action Appendix H. RFC1483 Quick Start BridgingAppendix I. PPPoA Quick Start Guide