ADTRAN TA 544 user manual Wan

Page 35

TA 544 User Manual/61200704L1-1A

Page 35 of 68

> WAN

Use the WAN menu (Figure 12) to configure WAN settings on the TA 544.

Figure 12. WAN Menu

L2 Protocol

Displays the current L2 protocol -ATM (read only).

ATM

Use the ATM menu to setup Data PVCs for the router.

Description

This is the text description for the PVC.

VPI

ATM virtual port identifier.

VCI

This is the ATM virtual channel identifier.

PCR

Peak Cell Rate. Enter the maximum bandwidth in cells per second.

QOS

Quality of Service. UBR = Low priority data.

Protocol

This is the protocol supported on the PVC.

RFC1483 IP

Use this selection to support IP on this DLCI.

Active

This selection enables IP on this PVC.

Far - End IP Address

This is the address of the NEXT hop router on this interface.

© 2001, ADTRAN, Inc.

TA 544 User Manual

Image 35

Contents 1200704L1 4200704L3 To the Holder of the Manual TrademarksSafety Instructions Limited Product Warranty USA International Contact Information2001, ADTRAN, Inc Repair and Return Customer Service, Product Support Information, and TrainingPresales Inquiries and Applications Support Post-Sale SupportTraining 800 615-1176, ext TrainingContents 2001, ADTRAN, Inc Figures 2001, ADTRAN, Inc Terminal Menu Firmware UpdatesVoice Over DSL Application Mount the Unit Unpack and Inspect the UnitSystem Info Firmware Revision Bootcode RevisionPart Number Serial NumberTelnet Access System ConfigOperating Mode Network Timing ModeSnmp Menu Maint Port Menu Password ProtectInstructions for Changing Passwords Step Action Network Time System Utility Upgrade FirmwareConfig Transfer Ping Layer One Interface Configuring WAN SettingsATM Config Dslam TypeData Scrambling ATM StatsAP Receive Cells Discarded AP Receive Cell ErrorsAP Rx Cells AP Rx OAM CellsDSL Rate Config Global Configuring the Router ConfigurationUse this menu to enter static routes to other networks Bridge Security Ethernet Menu EthernetMAC Address WAN This is the network mask used for this interface Use this menu to configure IP settings When set to Y ES, only IP RIP updates are sent All incoming packets from the WAN are not Bridge Table Configuring the Router StatusSession ARP cacheConfiguring the Router Logs Clear Network LogWrap ViewCall Control Configuring Voice Support ConfigVoice Stats Configuring Voice Support StatusGateway Stats PVC StatsModules Table Managing the Modules ModulesMode Managing the Modules V.35 SetupConfiguration Following settings are used for FRF5 Following settings are used for FRF8 Isdn Interfaces Appendix A. Specifications and FeaturesNetwork Interface ATM SupportSerial Data Security FeaturesPower Management OptionsPress Enter until a menu appears Appendix B. Updating TA 544 Firmware using XmodemUpdating Firmware via a Forced Download Updating Firmware via the Console Menus 2001, ADTRAN, Inc Appendix C. Updating TA 544 Firmware using Tftp Message Meaning Message Meaning Status Bar Ode Avigation H elp Enu Path Left PaneRight Window Pane Notation Window Pane NavigationNavigating Using the Keyboard Keys Additional Terminal Menu Window FeaturesSession Management Keystrokes Getting Help Application Diagram Voice Turn Up Step Action Appendix F. RFC1483 Quick Start IP Routing WAN Options Appendix G. RFC1483 Quick Start IP Routing with NATBridging Step Action Appendix H. RFC1483 Quick Start BridgingAppendix I. PPPoA Quick Start Guide