ADTRAN TA 544 Configuring the Router Status, Session, ARP cache, Bridge Table, IP Routes

Page 40

TA 544 User Manual/61200704L1-1A

Page 40 of 68

LAN-TO-WAN (OUT)	The packets which come out toward the
	WAN from the TA 544 can be filtered in
	three ways:
DISABLED (DEF)	Turns off packet output filtering. No
	outgoing packets are blocked.
BLOCK ALL	All outgoing packets to the WAN are blocked
	except as defined in the FILTERS/OUT
	EXCEPTIONS list.
FORWARD ALL	All outgoing packets to the WAN are not
	blocked except as defined in the FILTERS/
	OUT EXCEPTIONS list.
OUT EXCEPTIONS	This is a list of up to 32 entries. The setup is exactly
	the same as the FILTERS/OUT EXCEPTIONS list.

Configuring the Router – Status

Use the ROUTER/STATUS menu to view and set the parameters shown in Figure 13. The ROUTER/STATUS screens give the user useful information for debugging the current routes in the TA 544.

Figure 13. Router/Status Menu

> Session

This menu maintains statistics about the active ATM PVCs.

> ARP cache

This is a listing of the currently connected Ethernet port on the LAN.

> Bridge Table

This shows the detected MAC addresses and the interface to which they are associated.

> IP Routes

This shows the current routes in the TA 544 and their use.

TA 544 User Manual

© 2001, ADTRAN, Inc.

Image 40

Contents 1200704L1 4200704L3 Trademarks To the Holder of the ManualSafety Instructions Limited Product Warranty International Contact Information USA2001, ADTRAN, Inc Customer Service, Product Support Information, and Training Presales Inquiries and Applications SupportPost-Sale Support Repair and ReturnTraining Training 800 615-1176, extContents 2001, ADTRAN, Inc Figures 2001, ADTRAN, Inc Firmware Updates Terminal MenuVoice Over DSL Application Unpack and Inspect the Unit Mount the UnitSystem Info Bootcode Revision Part NumberSerial Number Firmware RevisionSystem Config Operating ModeNetwork Timing Mode Telnet AccessSnmp Menu Instructions for Changing Passwords Step Action Password ProtectMaint Port Menu Network Time Upgrade Firmware System UtilityConfig Transfer Ping Configuring WAN Settings ATM ConfigDslam Type Layer One InterfaceATM Stats Data ScramblingAP Receive Cell Errors AP Rx CellsAP Rx OAM Cells AP Receive Cells DiscardedDSL Rate Config Configuring the Router Configuration GlobalUse this menu to enter static routes to other networks Bridge Security Ethernet Ethernet MenuMAC Address WAN This is the network mask used for this interface Use this menu to configure IP settings When set to Y ES, only IP RIP updates are sent All incoming packets from the WAN are not Configuring the Router Status SessionARP cache Bridge TableConfiguring the Router Logs Network Log WrapView ClearConfiguring Voice Support Config Call ControlConfiguring Voice Support Status Gateway StatsPVC Stats Voice StatsManaging the Modules Modules Modules TableConfiguration Managing the Modules V.35 SetupMode Following settings are used for FRF5 Following settings are used for FRF8 Appendix A. Specifications and Features Network InterfaceATM Support Isdn InterfacesSecurity Features PowerManagement Options Serial DataUpdating Firmware via a Forced Download Appendix B. Updating TA 544 Firmware using XmodemPress Enter until a menu appears Updating Firmware via the Console Menus 2001, ADTRAN, Inc Appendix C. Updating TA 544 Firmware using Tftp Message Meaning Message Meaning Enu Path Left Pane Status Bar Ode Avigation H elpWindow Pane Navigation Right Window Pane NotationAdditional Terminal Menu Window Features Navigating Using the Keyboard KeysSession Management Keystrokes Getting Help Application Diagram Voice Turn Up Step Action Appendix F. RFC1483 Quick Start IP Routing WAN Appendix G. RFC1483 Quick Start IP Routing with NAT OptionsAppendix H. RFC1483 Quick Start Bridging Bridging Step ActionAppendix I. PPPoA Quick Start Guide