ADTRAN TA 544 user manual Configuring Voice Support Config, Call Control

Page 43

TA 544 User Manual/61200704L1-1A

Page 43 of 68

Configuring Voice Support – Config

Use the VOICE/CONFIG menu to view and set the parameters shown in Figure 15.

Figure 15. Voice/Config Menu

> Call Control

The CALL CONTROL setting is used to configure the correct Voice Gateway protocol for voice signaling control be- tween the TA 544 and the configured Gateway. The CALL CONTROL setting must be configured correctly before the voice circuits will work correctly. The TA 544 supports Jetstream, Tollbridge, and CopperCom Voice Gateways.

> VPI

The VPI setting is used to configure the TA 544 virtual path setting used to communicate with the configured Voice Gateway.

> VCI

The VCI setting is used to configure the TA 544 virtual circuit setting used to communicate with the configured Voice Gateway.

© 2001, ADTRAN, Inc.

TA 544 User Manual

Image 43

Contents 1200704L1 4200704L3 To the Holder of the Manual TrademarksSafety Instructions Limited Product Warranty USA International Contact Information2001, ADTRAN, Inc Repair and Return Customer Service, Product Support Information, and TrainingPresales Inquiries and Applications Support Post-Sale SupportTraining 800 615-1176, ext TrainingContents 2001, ADTRAN, Inc Figures 2001, ADTRAN, Inc Terminal Menu Firmware UpdatesVoice Over DSL Application Mount the Unit Unpack and Inspect the UnitSystem Info Firmware Revision Bootcode RevisionPart Number Serial NumberTelnet Access System ConfigOperating Mode Network Timing ModeSnmp Menu Instructions for Changing Passwords Step Action Password ProtectMaint Port Menu Network Time System Utility Upgrade FirmwareConfig Transfer Ping Layer One Interface Configuring WAN SettingsATM Config Dslam TypeData Scrambling ATM StatsAP Receive Cells Discarded AP Receive Cell ErrorsAP Rx Cells AP Rx OAM CellsDSL Rate Config Global Configuring the Router ConfigurationUse this menu to enter static routes to other networks Bridge Security Ethernet Menu EthernetMAC Address WAN This is the network mask used for this interface Use this menu to configure IP settings When set to Y ES, only IP RIP updates are sent All incoming packets from the WAN are not Bridge Table Configuring the Router StatusSession ARP cacheConfiguring the Router Logs Clear Network LogWrap ViewCall Control Configuring Voice Support ConfigVoice Stats Configuring Voice Support StatusGateway Stats PVC StatsModules Table Managing the Modules ModulesConfiguration Managing the Modules V.35 SetupMode Following settings are used for FRF5 Following settings are used for FRF8 Isdn Interfaces Appendix A. Specifications and FeaturesNetwork Interface ATM SupportSerial Data Security FeaturesPower Management OptionsUpdating Firmware via a Forced Download Appendix B. Updating TA 544 Firmware using XmodemPress Enter until a menu appears Updating Firmware via the Console Menus 2001, ADTRAN, Inc Appendix C. Updating TA 544 Firmware using Tftp Message Meaning Message Meaning Status Bar Ode Avigation H elp Enu Path Left PaneRight Window Pane Notation Window Pane NavigationNavigating Using the Keyboard Keys Additional Terminal Menu Window FeaturesSession Management Keystrokes Getting Help Application Diagram Voice Turn Up Step Action Appendix F. RFC1483 Quick Start IP Routing WAN Options Appendix G. RFC1483 Quick Start IP Routing with NATBridging Step Action Appendix H. RFC1483 Quick Start BridgingAppendix I. PPPoA Quick Start Guide