![](/images/new-backgrounds/1206271/20627123x1.webp)
1-4 CHAPTER 1: OVERVIEW
NETBuilder II Systems Use the following checklist to install system software, boot the system, and with a CEC 20 Module configure basic settings on a NETBuilder II system that has a CEC 20 module.
Install System Software and Boot — Refer to Chapter 4
❑Select an installation option and proceed to appropriate installation section:
❑Install software from flash memory card and boot the system. or
❑Install software from
Change the Primary Boot Source — Refer to Chapter 5
❑Change the primary boot source default as needed.
Configure Basic Settings — Refer to Chapter 6
❑Log on to the system.
❑Familiarize yourself with the
❑Obtain Network Manager privilege level.
❑Change the Network Manager password.
❑Adjust the time and date if necessary. Time and date are preset and may need to be adjusted for your time zone.
❑Set system administrator information:
❑System name
❑System location
❑System contact name and phone number
❑Assign IP addresses/subnet masks to individual ports or one address to the system.
❑Set up the bridge/router for SNMP.
❑Set up NETBuilder security.
❑Use the Quick Installation Utility for further configuration.
Configure Specific Services for Your Network — Refer to Using NETBuilder
Family Software and Reference for NETBuilder Family Software.