Chapter 6 Maximizing Avaya P460 Availability
The following screen capture shows the process:
This command may overwrite the neighbor SPV software and reset both SPVs
***Confirmation *** - do you want to continue (Y/N)? y Copying Bank A to the neighbor SPV ...
Copying Bank A to the neighbor SPV done Copying Bank B to the neighbor SPV ...
Copying Bank B to the neighbor SPV done
Copying Embedded Web image to the neighbor SPV ...
Copying Embedded Web image to the neighbor SPV done Setting boot bank of the neighbor SPV ...
Setting boot bank of the neighbor SPV done Setting chassis sync on for the neighbor SPV...
Setting chassis sync on for the neighbor SPV done SPVs are resetting.
Please wait till the process is finished. The SPVs will be synchronized after the reset is completed
Note: After the transfer is finished, the Supervisor modules are reset automatically.
—After the reset the configuration files of the Active Supervisor Module are copied to the Standby Supervisor Module.
This process can take up to two minutes.
Configuration File Synchronization
Three configuration files are stored in the Supervisor module flash memory:
•Layer 2 configuration
•Layer 3 running configuration
•Layer 3 startup configuration
If two Supervisor modules are present, the configuration is automatically synchronized between the Active and Standby Supervisor modules.
•Initial configuration synchronization takes place after the boot: this process can take up to thirty seconds.
•Layer 2 configuration changes are saved in both Supervisor modules when you press Enter.
The Supervisor module Ethernet outband interface configuration is not synchronized between the modules.
Avaya P460 Installation and Maintenance Guide | 37 |