Chapter 9 User Authentication
Allowed Managers
With the Allowed Managers feature, the network manager can determine who may or may not gain management access to the switch. The feature can be enabled or disabled (default is disabled). When enabled, only those users that are configured in the Allowed Managers table are able to gain Telnet, HTTP, and SNMP management access to the switch.
You can configure up to 20 Allowed Mangers by adding or removing their IP address from the Allowed Managers List.
Note: The identification of an “Allowed Manager” is done by checking the Source IP address of the packets, thus if the Source IP address is modified on the way (NAT, Proxy, etc.), even an “Allowed Manager” will not be able to access the P460.
Allowed Manager CLI Commands
In order to... | Use the following command... |
|
|
|
|
When set to enabled - only | set allowed managers |
managers with ip address specified |
|
in the allowed table will be able to |
|
access the device |
|
|
|
Add/delete ip address of manager | set allowed managers ip |
to/from the allowed table |
|
|
|
Show the IP addresses of the | show allowed managers table |
managers that are allowed to access |
|
the device |
|
|
|
Show whether the status of allowed | show allowed managers status |
managers is enabled or disabled |
|
|
|
Show the IP addresses of the | show secure current |
managers that are currently |
|
connected |
|
|
|
60 | Avaya P460 Installation and Maintenance Guide |