Chapter 7 Establishing Switch Access
Note: If you connect your terminal to the Standby SPV, you can get access to all the CLI commands by opening a Session to the Active SPV. (See the Session command on page 63).
Establishing a Telnet Connection with the Switch (Inband)
Perform the following steps to establish a Telnet connection to the P460 for configuration:
You need to assign an inband interface IP address using a direct connection to the console serial port before you can establish the Telnet session.
1Connect your station to the I/O module (directly or via the network).
2Verify that you can communicate with the P460 using Ping to the inband interface IP of the P460. If there is no response using the Ping command, check the IP address and default gateway of both the P460 and the station.
The default subnet mask is 255.255.255.0.
3Start a Telnet session:
—From the Microsoft Windows® taskbar of your PC click Start and then Run or access the command prompt
—Start the Telnet session by typing: telnet <P460_IP_address>
For example: telnet 149.49.35.214
XThe Login Name prompt is displayed
4 Enter the default name root
XThe password prompt is displayed
5Enter the password root in lower case letters. You can now configure the P460.
Inband Interface Connection CLI Commands
In order to... | Use the following command... |
|
|
|
|
Configure the management | set interface inband |
interface |
|
|
|
Configure the management VLAN | set inband vlan |
ID |
|
|
|
Enable the inband interface | enable interface inband |
|
|
Disable the inband interface | disable interface inband |
|
|
42 | Avaya P460 Installation and Maintenance Guide |