Printing on Labels
•Only use labels recommended for laser printers.
•Verify that the labels’ adhesive material can tolerate a fusing temperature of 180°C (356°F) for 0.1 seconds.
•Make sure that there is no exposed adhesive material between the labels. Exposed areas can cause labels to peel
off during printing, which can cause paper jams. Exposed adhesive can also cause damage to printer components.
•Never print on the same sheet of labels more than once, or print on a partial sheet of labels.
• Do not use labels that are separating from the backing sheet or are wrinkled or damaged in any way.
•To prevent labels from sticking together, do not let the printed label sheets stack up as they are printed out.
To print on labels:
1Open the
2Load labels in the
side down and the top, short edge in first. Adjust the guide to fit the width of the labels.
3When you print, set the paper source to
Tray and the paper type to Labels, and select the appropriate size in the software application. For details, see the Software Section.
4.5
Using Print Materials
Printing on Preprinted Paper
•Preprinted paper is paper that has some type of printing on it before it is sent through the printer (paper that has a preprinted logo at the top of the page, for example).
•Letterhead must be printed with
•Ink on letterhead must be
•Forms and letterhead should be sealed in
•Before you load preprinted paper, such as forms and letterhead, verify that the ink on the paper is dry. During the fusing process, wet ink can come off of preprinted paper, reducing the print quality.
To print on preprinted paper:
1Open the
2Load letterhead in the
3When you print, set the paper source to