Samsung CLP-650 Series manual Network Menu CLP-650N only, Config TCP to Yes

Network Menu (CLP-650N only)

This menu lets you configure the network interface card installed in your printer according to how the network is set up. You can upgrade the network interface card firmware, and print the configuration. (*: the default setting)

Item	Explanation
	Options: Yes, No
Config Network	Sets whether or not you configure the network. If
	you select Yes, you can configure the TCP/IP,
	Netware and AppleTalk menus.
	Options: Yes, No
	Select whether you set the IP address or not.
Config TCP	If you select Yes, you can configure the IP
	address.
	If you select Yes, the IP Get Method option
	appears on the display. You can select how to get
	the IP address.

	Options: Static, BOOTP, DHCP
	You can set this item only when you set the
	Config TCP to Yes.
IP Get Method	• Static: You can enter an IP address,
	subnetmask, and gateway manually.
	• BOOTP: The BOOTP server allots an IP address
	to you automatically.
	• DHCP: The DHCP server allots an IP address to
	you automatically.
	You can select this item only when you set IP
	Get Method to Static. This item lets you enter
	an IP address manually. Press the scroll button to
IP Address	set the value of the 1st byte between 0 and 255,
	and then press the Enter button.
	Set the value for the 2nd, 3rd, and 4th byte the
	same way.
	You can set this item only when you set IP Get
	Method to Static. This item lets you enter a
	subnet mask manually. Press the scroll button to
Subnet Mask	set the value of the 1st byte between 0 and 255,
	and then press the Enter button.
	Set the value for the 2nd, 3rd, and 4th byte the
	same way.

3.8

Item	Explanation
	You can set this item only when you set IP Get
	Method to Static. This item lets you enter a
	gateway manually. Press the scroll button to set
Gateway	the value of the 1st byte between 0 and 255, and
	then press the Enter button.
	Set the value for the 2nd, 3rd, and 4th byte the
	same way.
	Options: On, Off
AppleTalk	You can select whether or not to use the
	AppleTalk for Macintosh. If you select On, you can
	use the AppleTalk.
	Options: On, Off
	You can select whether or not to use the Netware
Netware	protocol.
	If you select On, you can access the Config
	Netware menu item.
	In the Config Netware menu, you can specify
	the frame type parameter used on your network.
	Options: Yes, No
	You can set this item only when you set
Config Netware	Netware to On. This item lets you select
	whether or not you set the frame type parameter.
	Select Yes to select the frame type.
	If you select Yes, the IPX Frame Type option
	appears on the display.
	Values: Auto, EN_8022, EN_8023, EN_II,
	EN_SNAP
	You can select this item only when you set
	Config Netware to Yes. This item lets you
	select the IPX Frame Type.
IPX Frame Type	• Auto: You can set a frame type automatically.
	• EN_8022: Select this value to use the IEEE
	802.2 frame type.
	• EN_8023: Select this value to use the IEEE
	802.3 frame type.
	• EN_II: Select this value to use the ETHERNET
	II frame type.
	• EN_SNAP: Select this value to use the SNAP
	frame type.
Reset Network	This item reboots the network interface card.
	This item performs a simple reset and restores
Default Set	the factory default settings for the network
	configuration.

Using the Control Panel