Installation
Making a Copy
Copy a document to verify proper machine operation. You can copy single or multiple page documents.
1 Turn the page face down and insert it into the document feeder.
2
3
4
5
Adjust the document guide to match the width of the document.
Feed the document into the machine. The automatic document feeder pulls in the page. If necessary, press RCV.Mode$!Contrast to choose the desired contrast for the document.
Press | (Copy). |
The display shows ‘NUMBER OF COPIES’.
•If you want one copy at preset copy rate, press Copy again and skip step 5 below.
•If you want two or more copies, press Start/Enter and enter the number.
•If you want to change copy rate, select COPY RATE by pressing!➛!or ❿ and Start/ Enter. You can scale the document from 75% to 100% by entering the number, and this change will remain on the
Press (Start/Enter) when the number on the display is correct. Copying begins. The display shows the page number that is being copied. When the machine runs out of paper, supply additional paper and press Start/Enter, then remaining copy will resume.
12