Samsung SF-3100 manual Using Remote Commands, Code Operation

Page 49

The Answering Machine

3 Enter the Remote Command corresponding to the operation within ten seconds.

•When the specified operation is complete, you hear a short beep. You can then enter another command for another operation. If you enter a remote code while the machine is responding to your command, the unit stops the current operation and performs new opera- tion. For the Remote Commands, "Using Remote Commands" below.

Using Remote Commands

4 Press #0 to finish the remote session. Important: if you don’t enter ‘#0’, your machine might not hang up for several minutes.

The chart below describes which Remote Code you have to enter for remote operation:

Code

Operation

 

 

 

 

 

 

#0

Exits remote control mode.

 

 

 

 

 

 

#1

Changes the greeting message. After entering the command, speak into the handset. When you finish,

 

 

 

press #. If you run out of recording time, the machine stops and plays back the message.

 

 

 

 

 

 

#2

Plays back all messages. The machine beeps and plays all messages. If there are no messages, the

 

 

 

machine beeps four times and waits for another command to be entered.

 

 

 

 

 

 

#3

Stops the ICM play and waits for remote code when playing ICMs (#2, #5).

 

 

 

 

 

 

#4

Skips a message backward. The machine skips the current message and plays the previous one.

 

 

 

 

 

 

#5

Plays back new messages. The machine beeps and plays all new messages. If there are no new

 

 

 

messages, the machine beeps four times and waits for another command to be entered.

 

 

 

 

 

 

#6

Skips a message forward. The machine skips the current message and plays the next one.

 

 

 

 

 

 

#7

Erases the message currently playing, and plays back the next message.

 

 

 

 

 

Chapter

#8

Turns TAM Mode on/off. The machine plays the greeting message when TAM Mode is turned on.

 

 

Each time you press #8 thereafter, TAM mode is turned off, then back on.

 

 

 

 

 

 

 

 

#9

Erases all the messages.

 

 

 

 

 

 

#✽1

Activates Message Paging feature. If you do not set up Message Paging before you leave, you cannot

 

 

 

turn it on from a remote phone. You will hear error beeps.

 

4

 

 

 

#✽2

Changes Message Paging destination number and activates the feature. Press #✽2. When you hear

 

 

 

 

the confirm tone (two-short double beeps), enter the new destination number. You cannot include # as

 

 

 

a dial number. Use ✽ to insert a PAUSE between numbers. When you finish entering number, press

 

 

 

 

 

#.

 

 

 

 

 

 

#✽3

Deactivates Message Paging feature.

 

 

 

 

 

 

✽#✽

Exits the fax machine from answering mode.

 

 

 

This code is used at a phone extension connected to the same line as your fax machine

 

 

 

 

 

 

4-9

Page 48 Page 50
Image 49
Page 48 Page 50
Contents SF-3100/SF-3100T Electronics Important Precautions and Safety Information Case of Interference Fax Branding You should also know that Telephone Company InformationPage Table of Contents Answering Machine Care and Maintenance 1SETUP List of Features Rear View Front ViewErase ResolutionPlay AnswerScroll/Volume and ❿ SetupNumber keypad Receive Mode/ContrastSetup Press Setup SettingPress Start/Enter when finished Number NameKeypad Character Assignments How to Enter LettersPress the appropriate button for the letter you want Key Assigned numbers, letters, or charactersPress Start/Enter when the date and time appear correctly Recording TAM1 Message SF-3100T only Automatic Dialling Storing a Number for One-Touch Dial- ling One-Touch DiallingPress and hold a One-Touch button for about two seconds Enter the number you want to store up to 46 digitsPress the desired One-Touch button through Dialling a One-Touch NumberStoring a Number for Speed Dialling Speed DiallingEnter the two-digit location number 01 through Press Start/Enter Dialling a Speed NumberPress Speed Enter a two-digit speed dial location numberStoring Speed Dial Numbers for Group Dialling GroupPress a One-Touch button you want to use for Group Dial Using Group Dialling Multi-Address transmission Automatic Dialling FAX Machine Loading Document Sending a FaxTurn the page face down Super Fine Setting Docu- ment Resolution and ContrastSending a Fax Manually after Talking Press Start/Enter when you hear the fax tonePick up the handset Replace the handsetSending a Fax Automatically Automatic Redial Reception Modes Receiving a FaxPick up the handset and answer it when the telephone rings Receiving in FAX Mode Receiving in TEL ModeHang up the handset Receiving Auto Mode Receiving in TAM Mode SF-3100 Receiving in TAM Mode SF-3100T Answer the call on the extension phone Receiving via an Extension Tele- phone Cancelling ReceptionVoice Request Pick up the handset and answer it when the phone ringsAnswering a Voice Request Making a Voice RequestFax Machine Answering Machine Checking Your TAM Greeting Message Recordng TAM Message SF-3100T onlyPress OGM Monitoring an Incoming Call To Erase All Recorded Messages Erasing Old Messages You’ve HeardTo Erase a Selected Message Press ErasePlaying Back Newly Received Caller Messages Playing Back MessagesPlaying Back All Messages Simply press PlayTo skip backward Skipping Backward or ForwardTo skip forward Message Paging operates as follows Message PagingPlace a call to your fax machine from a Touch- Tone phone Accessing the MachineCode Operation Using Remote CommandsAnswering Machine Advanced FAX Enter the fax number Chapter Turn the document face down and feed it into DelayedEnter the time in 24-hour format Polling Setting Send PollingSetting Receive Polling To Cancel the Scheduled Job Special Features To Redial the Number in Memory To Redial the Last Number CalledPress Redial/Pause Press and hold Redial/Pause for about two secondsHang up the handset when the person answers Using RecallTo Insert a Pause Enter the phone number to transfer it to someone elseChain Dialling User Reports To Print a report Power Fail ReportVoice Status SF-3100T only Multi-CommunicationPress Setup Select ‘SYSTEM SETUP’ or ‘TAM SETUP’ SF Setting SYSTEM/TAMSF-3100T only OptionsUser Options Option Suboption System Setup OptionsSpecial Features Caller ID Options Status TAM Options SF-3100T onlySetup VolumeScroll through the options by pressing or ❿! button Press Start/Enter to confirmSelect what you want to delete by pressing or ❿ Clearing MemorySpecial Features Care and Maintenance Cleaning the Document Scanner Carefully wipe the Scanning Glass with a soft, dry cloth Replacing Print Cartridge Chapter Wiping the Print Nozzles and Contacts Cleaning the CartridgeGently blot and wipe the contacts and nozzles dry Re-install the Cartridge and close the Cover and PanelClean the Cartridge Carrier contacts Cleaning the Car- tridge Carrier Contacts and DeflectorPlug in the power cord and your fax machine will initialize Remove the Print CartridgeExamine the test pattern Cleaning the PrintheadInk Level View Be Careful Adjust ShadingPrint Cartridge Maintenance Display Meaning LCD Error MessagesProblem Solution Fax ProblemsPaper Feeding Problems Print Quality ProblemsDocument Jams During Transmission Clearing JamsIf the paper is jammed in the Received Paper Output Area Paper Jams Dur- ing PrintingIf the paper is jammed in the Paper Feed Area Remove the jammed paper as shown belowCare and Maintenance 8APPENDIX MH, MR, MMR SpecificationsPaper Type and Sizes for the ASF1 Paper size Inches Paper Weight Millimeters70 g/m 2 ~ 90 g/m Single Sheet Or More Sheets Acceptable Documents for ADF1Sample of ITU 4% Chart reduced to 60.5% Installation Guide JB68-00227A Rev Important Precautions and Safety Information Page Common Parts Make Sure Everything Is in the BoxFamiliarizing Yourself with Your New Machine Rear View Connections Connection DiagramChoosing a Location Document Tray HandSetTelephone Line Document Exit TrayExtension Phone Optional, SF-3100 only AC Power CordBackup Battery SF-3100T only Pull the Paper Support on the ASF all the way up Loading PaperBefore loading papers, push down the blue Paper Lever Remove the new print cartridge from its packaging Installing Print CartridgeInsert the print cartridge in the carrier Press Copy Making a Copy
Top Page Image Contents