■On the Multiscreen Monitor
●Selecting the Multiscreen Monitor
1.Press the [SPOT/MULTI] button to turn the LED in the button off. The multiscreen monitor is ready to be oper- ated.
SPOT
MULTI
2.Follow the descriptions below for each monitoring mode on the multiscreen monitor.
●Viewing a Single Live
The multiscreen monitor can display a single live spot image.
Operating procedures are the same as for "On the Spot Monitor" except for selecting the multiscreen monitor.
●Zooming a Single Live
A single live or playback image on the multiscreen monitor can be zoomed.
1.Display the desired single live or playback image on the multiscreen monitor pressing the [ZOOM] button an appropriate number of times.
MULTISCREEN
SELECT
ZOOM
2.Hold down the [ZOOM] button for 2 seconds to enlarge the image.
MULTISCREEN
SELECT
ZOOM
4.Press the JogDial repeatedly to select an appropriate
enlargement ratio.
Pressing the JogDial : Increases the ratio (x2 → x4)
5.Hold down the [ZOOM] button for 2 seconds to cancel the zoom mode.
Notes:
•The maximum zooming ratio (x4) will be reduced to x2 when SIF is selected for RESOLUTION in the SYSTEM SETUP menu.
•To quit enlargement
•While displaying a zoomed live image, pressing the [PLAY] button will quit enlargement and start normal playback.
•While displaying a zoomed playback image, pressing the [STOP] button will quit enlargement and display a live image.
•For other cases, hold down the [ZOOM] button for 2 seconds.
•The images on the screen may wave vertically when enlarging live or playback images in the SIF mode. It is recommended that you select NORMAL for RESOLU- TION when the display quality is considered much important.
●Viewing a Quad Live Sequence
A series of quad and single images is displayed in succes- sion on the multiscreen monitor. One sequence can be pro- grammed in the MULTI SEQ SETUP menu with an input assignment and display duration for each step.
1.Select the multiscreen monitor.
2.Press the [SEQUENCE] button to run the sequence. The LED in the [SEQUENCE] button lights up.
SEQUENCE
Note: During the sequence, the LEDs of the [CAMERA SELECT] buttons light up corresponding to the selected cameras that send images to the monitor.
Multiscreen monitor
(4A)
12
1 2
34
3.Rotate the JogDial to move the zoomed area to the right and left, or press the [D] or [C] button to move the area up or down.
3.During the sequence, press the [SEQUENCE] button to pause. The LED in the [SEQUENCE] button blinks.
4.Press the [SEQUENCE] button to restart the sequence. The LED turns to a steady light.
46