Panasonic WJ-HD220 manual Disk Menu, Abbreviation Status Required Capacity, Auto-remove

●DISK MENU

8Disk Menu

The menu appears if the hard disk error is found during power-up.

The buzzer beeps every 5 seconds, and the ERROR indicator turns off.

Press any button other than [STOP] to mute the buzzer beep.

The hard disk status and required operations are shown in the table.

DISK MENU

NO.1:XXX.XXGB

NO.2:XXX.XXGB

REMOVE LINK SET→ HDD FORMAT SET→

RESTART SET→

Hard Disk Status

Operation

Abbreviation	Status	Required	Note
Capacity	Normal status	–
ERR	Writing error	Format, remove link ,or replace HDD	WR1 or WR2 appears in SYSTEM LOG
		if erred even after formatting.	when indicating a writing error.
	LOST or * status was left for	Same as above.
	one minute.
*	Awaiting format	Restart or Format	All existing HDD have been previously
			used in another WJ-HD220.

LOST HDD physically removed Remove link, or add a new HDD.

HDD is removed without executing REMOVE LINK command.

ADD	HDD added, and awaiting	Format
	format

–	Previous time and this time,
	HDD physically or logically
	removed

REMOVE LINK command has been previously carried out.

You can implement any of the following operations as necessary.

REMOVE LINK: Logically removes the HDD link.

HDD FORMAT: Formats the HDD.

RESTART: Closes the menu, and restarts the recorder.

The menu can also be displayed manually when you need to format the HDD or remove the logical link.

1.Turn off the power of the recorder once, and turn it on again.

The multiscreen monitor displays the message "SYSTEM CHECK DONE! TO OPEN DISK MENU, PUSH STOP KEY".

2.Press the [STOP] button. The DISK MENU opens.

3.Select REMOVE LINK, HDD FORMAT, or RESTART.

Auto-remove

When no button is pressed for one minute after opening the DISK MENU, the recorder will logically remove a disk that meets any of the conditions below.

•An HDD has been categorized as " * ", "LOST", or "ERR".

•Restart was repeated 3 times due to writing error.

96