●When Full Indicator is Lit (Resetting Disk End)
8FULL Indicator
The FULL indicator will light up when STOP is set to DISK END MODE, provided that the disk space nears the end.
To reset it, do the following.
8DISK END Setup
1.Hold down the [STOP] button for 2 seconds to open the
MAIN MENU.
TIMER |
| OFF |
REC SETUPO |
| |
EXT REC | SETUPO |
|
DISPLAY SETUPO |
| |
SYSTEM SETUPO |
| |
ALARM SETUPO |
| |
COMMUNICATION SETUPO | ||
SWITCHER SETUPO |
| |
SYSTEM INFORMATIONO | ||
LANGUAGE |
| ENGLISH |
●When Error Indicator is Lit
Refer to your dealer for servicing when this happens.
8HDD Check
The recorder checks the hard disk when the recorder is turned on, or when the HDD CHECK time specified in the menu setup comes during operation.
The recorder warns you of any error detected as fol- lows.
Error indicator blinks.
Warning Out terminal on the rear panel turns active.
"HDD ERROR" will appear when there is no disk installed in the recorder.
HDD ERROR
2.Select SYSTEM SETUP, and press the JogDial to open the SYSTEM SETUP menu.
SYSTEM SETUP | (1 OF 2) |
PASSWORD LOCK | OFF |
ALL→ | ***** |
OPERATION→ | ***** |
KEYLOCK BUZZ | OFF |
SKIP | 5PAGE |
SIMUL REC&PLAY | ON |
ALTER DETECT | OFF |
DISK END MODE | CONTINUE |
DISK END BUZZ | ON |
3.Move the cursor to DISK END MODE, and rotate the JogDial to select CONTINUE. Then press the JogDial.
STOP: Stops recording at the disk end.
CONTINUE: Overwrites from the start of the disk.
4.Press the [STOP] button to return to the MAIN MENU.
5.Hold down the [STOP] button for 2 seconds to return to normal operations.
The recorder starts operating in continuous mode up to the disk end.
If you wish the recorder to revert to STOP for DISK END MODE, repeat above steps 1 through 5, but select STOP in step 3.
When this happens, turn off the power. New disk(s) should be installed on the recorder, referring to INSTALLATION.
8When Error Detected
1.Turn off the recorder, and turn it on again. It will perform as follows.
DISK MENU is displayed. Error indicator blinks.
Buzzer beeps every 5 seconds.
2.Press any buttons other than [STOP] to stop the indica- tor blinking and buzzer beep.
3.See DISK MENU on the next page for further opera- tions.
95