Panasonic WJ-HD500A manual Connection with the DVD Extension Unit, Switch Settings

■Connection with the DVD Extension Unit

The WJ-HD500A Digital Disk Recorder controls the WJ- HDE510 DVD Extension Unit through the SCSI chain.

<Connection with the DVD Extension Unit without HDD>

The figure shows a WJ-HDE510 without an HDD.

The DVD-RAM is used for backup of the data recorded on the WJ-HD500A Digital Disk Recorder.

1.Connect between the COPY port on the WJ-HD500A and the COPY IN port on the 1st DVD Extension Unit with the supplied (WJ-HDE510) SCSI cable.

Plug the cable end with magnetic core into the COPY port, and the other ends into the COPY IN port.

2.Connect between the EXT STORAGE port on the WJ- HD500A and the EXT IN port on the 2nd Extension Unit with the supplied (WJ-HDE510) SCSI cable.

Plug the cable end with magnetic core into the EXT STORAGE port, and the other ends into the EXT IN port.

Digital Disk Recorder
WJ-HD500A	COPY port
SCSI ID=6 and 7

EXT
STORAGE	IN		EXT STORAGE					COPY				GEN-LOCK OUT		SIGNAL GND
	SPOT										DATA	REMOTE(WV-CU50)				10/100BASE-T	AC
													SERIAL
	OUT																IN
	OUT			CONTROL			ALARM		MODE
	MULTI SCREEN OUT AUDIO		14		12	11		9		7	6	5	4	3	2	1
	16	15		13			10		8
	IN
																	ON
																	OFF
	OUT
	16	15	14	13	12	11	10	9	8	7	6	5	4	3	2	1	POWER
								VIDEO
					CONTROL port

SCSI cable
(supplied with	SCSI cable (supplied)
Extension Unit)

				DVD Extension Unit #1
	COPY IN			WJ-HDE510
				SCSI ID= not set
	EXT IN	COPY IN
	EXT OUT			AC IN
			G		POWER
	SCSI ID		THERMAL ERROR OUT
			NC		ON
HDD	-	TERMINATOR			OFF
INSTALLED	+	ON
NOT INSTALLED		OFF
					SIGNAL GND
EXT IN				Terminal board
	EXT IN
		OUT
	EXT OUT	ERROR
				AC IN	POWER
	SCSI ID	GND THERMAL	NC		ON
	–	TERMINATOR			OFF
	+	ON
		OFF

SIGNAL GND

The system can be expanded by up to 6 Extension Units.

To connect the other Extension Units, refer to the operating instructions of each unit for further informa- tion.

Extension Unit #2 WJ-HDE500/HDE505 SCSI ID=0 to 5

●Switch Settings

1.Set MODE switch #2 on the rear of the WJ-HD500A to OFF when connecting a DVD Extension Unit without an optional HDD.

Set the MODE switch to ON if other Extension Units are installed in the system.

2.Set the SCSI ID and TERMINATION of the Extension Units as required.

1 2 3 4

ON

MODE

22