FUNAI CR130TT8 owner manual Supplied Accessories, Symbols Used in this Manual, Location

Page 4

INTRODUCTION

LOCATION

For safe operation and satisfactory performance of the unit, keep the following in mind when selecting a place for its installation:

Shield it from direct sunlight and keep it away from sources of intense heat.

Avoid dusty or humid places.

Avoid places with insufficient ventilation for proper heat dissipation. Do not block the ventilation holes at the top and bottom of the unit. Do not place the unit on a carpet because this will block the ventilation holes.

Install the unit in a horizontal position.

Avoid locations subject to strong vibration.

Do not place the unit near strong magnetic fields.

Avoid moving the unit to locations where temperature differences are extreme.

Be sure to unplug the AC power cord from the outlet before carrying the unit.

TO AVOID THE HAZARDS OF ELECTRICAL SHOCK AND FIRE

Do not handle the power cord with wet hands.

Do not pull on the power cord when disconnecting it from an AC outlet. Grasp it by the plug.

If, by accident, water is spilled on the unit, unplug the power cord immediately and take the unit to our authorized service center for servicing.

Do not place anything directly on top of the unit.

The serial number of this product may be found on the back of the unit. No others have the same serial number as yours. You should record the number and other vital information here and retain this book as a permanent record of your purchase to aid identification in case of theft.

date of purchase

 

dealer phone No.

 

serial No.

 

dealer purchase from

 

model No.

 

dealer address

 

 

 

 

 

 

 

Note about recycling:

This product’s packaging materials are recyclable and can be reused. Please dispose of any materials in accordance with your local recycling regulations.

Batteries should never be thrown away or incinerated but disposed of in accordance with your local regulations concerning chemical wastes.

5Supplied Accessories

owner’s manual

 

 

 

remote control

(1EMN22502)

 

 

 

(NE613UE)

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

/

AUDIO INFO

1 2 3

4 5 6

7 8 9

CHANNEL

–/ENTRETURN

0 +100

CH

VOLVOL

CH

batteries (AA x 2)

INPUT SLEEP

SELECT

If you need to replace these accessories, please refer to the part No. with the illustrations and call our toll free customer support line found on the cover of this manual.

Depending on your antenna system, you may need different types of combiners (mixers) or separators (splitters). Contact your local electronics store for these items.

5Symbols Used in this Manual

The following is the description for the symbols used in this manual.

Description refers to:

DTV

: Digital TV operation

TV

: Analog TV operation

• If neither symbol appears under the function heading, operation is applicable to both.

4

EN

Image 4
Contents CR130TT8 Introduction Important note is located on the rear of the cabinetPrecautions RADIO-TV InterferenceSupplied Accessories Symbols Used in this ManualLocation To Avoid the Hazards of Electrical Shock and FireContents FeaturesDTV/TV/CATV Installing the Batteries Remote Control FunctionBattery Precautions AC power cord Control PanelRear Panel ANT. in jack p8Connection Basic ConnectionAntenna Cable Connection Connection to Cable Box or Satellite BoxExternal Device Connection Video ConnectionRCA video cable RCA audio cable Digital Audio Output ConnectionInitial Setting Initial SetupMain Menu Before you beginAuto Channel Scan Language SelectionPress Menu to display the main menu English Español FrançaisWatching TV Volume AdjustmentChannel Selection Accessing External Devices Switching Digital / Analog ModeScreen Information TV Screen Display Mode Sleep TimerTo Cancel the Sleep Timer LetterboxOptional Setting Channel Add/DeleteUse VOL X/Y to select ADD or Delete To add or delete another channels, repeat steps 4 toPicture Adjustment Closed CaptionDtvcc Then press VOLDtvcc Style Chip DpageTo Set the Sub Ratings Enter password again in Confirm Password space Mpaa RatingTroubleshooting Troubleshooting GuideWith an AM radio MaintenanceWith a digital camera Including built-in cell phone cameras Information Memo Limited Warranty 13 Télévision Numérique / Analogique Importantes Consignes de Sécurité Précautions à Prendre Brouillage RADIO-TVAccessoires Fournis Symboles Utilisés dans ce ManuelEmplacement Pour Éviter LES Risques DE Choc Électrique ET D’INCENDIECaractéristiques ContenuInsérer les Piles Fonction de TélécommandePrécautions Concernant les Piles Panneau de Commande Panneau ArrièreConnexion Connexion de BaseRemarque Connexion du Câble d’AntenneConnexion d’un Appareil Externe Connexion VidéoCâble audio RCA Connexion par la Sortie Audio NumériqueConfiguration Initiale Installation InitialeMenu Principal PréliminairesEx. mode TV numérique 5Sélection de la LangueMenu sur écran EnglishRéglage du Volume Regarder LA TélévisionSélection de Chaîne Pour utiliser les touches NumériquesInformations sur Écran AffichéesInformations DE Diffusion Informations de DiffusionAppuyezsommeil. sur Sleep pour régler la minuterie de Minuterie de SommeilPour annuler la minuterie de sommeil Configuration Optionnelle Ajout/Suppression de Chaîne5Réglage de l’Image CouleurTeinte NettetéPuis appuyez sur VOL Ex. mode TV numérique Utilisez CH K / L pour sélectionner CONFIG. DTVSous-titres DTV Style Dtvcc Circuit Pour Spécifier les Cotes Secondaires DE PASSE, puis appuyez sur VOL Ex. mode TV numérique Télécommande pour saisir le nouveau mot de passe à ChiffresSaisissez de nouveau le mode de passe dans l’espace Appuyez sur les touchesDépannage Guide de DépannageAvec une radio AM Réglez la radio AM sur une fréquence non EntretienAvec un appareil photo numérique Glossaire Désignation des Chaînes de CâblodiffusionSpécifications Générales Spécifications ÉlectriquesMemo Garantie Limitée Manual del Usuario Importante para su Seguridad IntroducciónPrecauciones Interferencia DE RADIO-TELEVISIÓNAccesorios Suministrados Símbolos Utilizados en este ManualManual del usuario Pilas AA xCaracterísticas ContenidoInstalación de las Pilas Función de Mando a DistanciaPrecauciones Sobre las Pilas Panel de Control Panel TraseroConexión Conexión BásicaNota Conexión de Cable de AntenaConexión de Dispositivo Externo Conexión de Cable de VídeoCable RCA de vídeo Conexión de Salida de Audio DigitalConfiguración Inicial Ajuste InicialMenú Principal Antes de empezarPresione Menu para visualizar el menú principal Utilice CH K/L para seleccionar su tipo dePresintonía deseado, y presione VOL Presione Menu para salirAjuste de Volumen Para VER LA TelevisiónSelección de Canal Para utilizar los botones numéricosPara Cambiar Entre el Modo Digital y el Modo Analógico Acceso a Dispositivos ExternosInformación de Pantalla Información de EmisiónModo de Visualización de Pantalla del Televisor Temporizador de ApagadoPresione Menu para mostrar el menú principal Ancho BuzónAgregar/Borrar Canales Ajuste OpcionalEj. modo TV digital Ajuste de Imagen Subtítulos CerradosOFF Utilice VOL X / Y para ajustar la calidadUtilice CH Utilice VOL X/Y repetidamente para cambiar el ajusteSelecciónelo si no desea DTVCC. Éste es el ajuste PredeterminadoEstilo Dtvcc Cuando no haya configurado su contraseña, introduzca DpáginaLas subcategorías, siga los pasos indicados Para Ajustar las SubcategoríasEj. TV-PG Vuelva a introducir la contraseña en el espacio Exclusivamente para público adultoSolución DE Problemas Guía de Solución de ProblemasCon una radio AM MantenimientoCon una cámara digital Información EMO Garantía Limitada