Eiki LC-XC1 owner manual Normal Function

LC-XC1

NORMAL FUNCTION

The normal picture level is preset on this projector at the factory and can be restored anytime you press the NORMAL button (located on the Top Control or on the Remote Control Unit). The “Standard” display will be displayed on the screen for a few seconds.

The Auto Image function is provided to automatically adjust Fine sync., Total dots, and Picture Position for most computers.

1

2

Press the MENU button and the ON-SCREEN MENU will appear. Press the POINT LEFT/RIGHT buttons to select AUTO IMAGE and press the SELECT button. Another dialog box AUTO IMAGE MENU will appear.

Move the arrow to an item that you want to adjust by pressing

the POINT UP/DOWN button. Change the setting On or Off by pressing the SELECT button.

Adjust the picture as necessary to eliminate flicker from the display.

This item can be adjusted manually. (Refer to page 28.)

The number of the total dots in one horizontal period. This item can be adjusted manually. (Refer to page 28.)

Adjustment of the position of the image. This item can be adjusted manually. (Refer to page 30.)

3 Move the arrow to “Go!” and press the SELECT button to start the Auto Image function.

This adjustment can be executed by pressing AUTO IMAGE button on the Top Control or on the Remote Control Unit.

Stored

Go!

.... Stores the On/Off setting of each item.

Starts the Auto Image Adjustment.

Quit . ...

NOTE:

Closes AUTO IMAGE MENU.

This menu cannot be operated when the input signal is from the COMPUTER INPUT-i (DIGITAL) terminal or “RGB,” “HDTV72Op,” “HDTV1O35i” or “HDTV1O8Oi” is selected on SYSTEM MENU (P24 and 25).

The Fine sync., Total dots, and Picture Position of some computers may not be fully adjusted with the Auto Image Function. In that case, manual adjustment is required to make fine image. (Refer to page 28 to adjust “Fine sync.” or “Total dots” and page 30 to adjust Picture Position.)

29