Eiki LC-XC1 owner manual Cabinet

Page 43

			LC-XC1
Problem:	Try these Solution

Remote Control Unit does not	Check the batteries.
work	Check the ALL-OFF switch on the Remote Control Unit is set to “ON.”.
	Make sure nothing is between the Remote Receiver and the Remote
		Control Unit.
	Make sure you are not too far from the projector when using the
		Remote Control Unit. Maximum operating range is 16.4’ (5m).
	Make sure the code of the Remote Control is set to conform to the
		projector. (See “SETTING” section on page 36, 37.)
Wireless Mouse function does	•	Check the cable connection between the projector and the computer.
not work.	•	Check the mouse setting on your computer.
		•	Turn the projector on before you turn on the computer.

WARNING:

High voltages are used to operate this projector. Do not attempt to open the

cabinet.

If the problem still persists after following all operating instructions, contact the sales dealer where you

purchased the projector or the service center. Give the model number and explain the difficulty. We will advise you how to obtain service.

This symbol on the nameplate means the product is Listed by Underwriters Laboratories Inc. It is designed and manufactured to meet rigid U.L. safety standards against risk of fire, casualty and electrical hazards.

43

Image 43

Contents Model LC-XC1 To the Owner Safety Instructions Compliances Table of Contents Color Systems Progressive scan signals and provide fine picture qualityProjector and computer with this Remote Control Unit only IBM-compatible and Macintosh computers up toLC-XC1 Projector side AC Outlet side Room Light Positioning the ProjectorLatches on both sides of the projector Adjustable FeetInput Terminals Refer to Reset function excessivelyWhen using the Wired / Wireless This projector uses a micro processor to controlLC-XC1 LC-XC1 Indicators Laser Pointer Function Compartment lid ReplaceFlow of ON-SCREEN Menu Menu BAR Appliance cannot be turned on Turn the Main on I OFF Switch to ON. The Lamp indicatorTurning on the Projector Turning OFF the ProjectorPress the Zoom !/∀buttons on the Top Control or on Zoom AdjustmentFocus Adjustment Lens Shift Adjustment∀button or the Point UP/DOWN buttons. Press Keystone AdjustmentTimer function Picture Freeze FunctionMenu Operation Direct OperationSystem Menu will appear To set the Computer system manually, select the mode onNo signal Automatic MULTI-SCAN SystemCompatible Computer Specifications Point UP/DOWN button and the Select button. To Reset Mode free Stored Quit Closes Image Menu Recalls the data previously adjustedReset Stores the adjusted data in the memoryNormal Function LEFT/RIGHT buttons, and then press the Select button Setting data in the memoryCloses This projector cannot display any ∀, SELECT, Right CLICK, or Point button. To adjustDisplayed. Correct the Keystone distortion by pressing Menu P24Menu Operation Direct OperationVideo I S-Video / Y, PbICb, Pr/Cr Video Signal from Y, Pb/Cb, Pr/Cr Jacks Video Signal from Video Jack or S-VIDEO JackProgressive CustomColor Noise reductionWide RegularDisplay Power off? messageBlue back Returns to the normal code Mode Remote controlSet the Remote control in Setting Menu to Mode To return to the normal code Mode 1, operate both projectorNot work properly InstallationOperating Wireless Mouse ConnectionAIR Filter Care and Cleaning Temperature Warning IndicatorParticles, it will reduce the Cooling Fans’ Cover Lamp Replacement Monitor TimerCleaning ThE Projection Lens No image Picture isTop/Bottom Reversed Some displays are not Seen duringCabinet Signal Scanning Frequency Dimensions W x H x DNet Weight Panel ResolutionTerminal Mini DIN 8-PIN MAC AdapterTerminal HDB1 5-PIN Terminal DVI 24-pinEiki Deutschland Gmbh