Eiki LC-XC1 owner manual Projector side AC Outlet side

Page 8

LC-XC1

CONNECTING THE AC POWER CORD

This projector uses nominal input voltages of 100-120 V or 200-240 V AC. The projector automatically selects the correct input voltage. It is designed to work with single- phase power systems having a grounded neutral conductor. To reduce the risk of electrical shock, do not plug into any other type of power system.

Consult your authorized dealer or service station if you are not sure of the type of power supply being in use.

Connect the projector with the peripheral equipment before turning the projector on. (Refer to pages 11 14 ror connection.)

CAUTION

For safety, unplug the AC Power Cord when the appliance is not used.

When this projector is connected to the outlet with the AC Power Cord, the appliance is in Stand-by Mode and consumes a little electric power.

NOTE ON THE POWER CORD

The AC Power Cord must meet the requirement of the country where you use the projector Confirm the AC plug type with the chart below. The proper AC power cord must be used. If the supplied AC Power Cord does not match the AC outlet, contact your sales dealer.

Projector side

AC Outlet side

8

Image 8

Contents Model LC-XC1 To the Owner Safety Instructions Compliances Table of Contents Progressive scan signals and provide fine picture quality Projector and computer with this Remote Control Unit onlyIBM-compatible and Macintosh computers up to Color SystemsLC-XC1 Projector side AC Outlet side Positioning the Projector Room LightAdjustable Feet Latches on both sides of the projectorInput Terminals Reset function excessively When using the Wired / WirelessThis projector uses a micro processor to control Refer toLC-XC1 LC-XC1 Indicators Laser Pointer Function Replace Compartment lidFlow of ON-SCREEN Menu Menu BAR Turn the Main on I OFF Switch to ON. The Lamp indicator Turning on the ProjectorTurning OFF the Projector Appliance cannot be turned onZoom Adjustment Focus AdjustmentLens Shift Adjustment Press the Zoom !/∀buttons on the Top Control or onKeystone Adjustment Timer functionPicture Freeze Function ∀button or the Point UP/DOWN buttons. PressDirect Operation Menu OperationTo set the Computer system manually, select the mode on No signalAutomatic MULTI-SCAN System System Menu will appearCompatible Computer Specifications Point UP/DOWN button and the Select button. To Reset Mode free Stored Quit Recalls the data previously adjusted ResetStores the adjusted data in the memory Closes Image MenuNormal Function Closes Setting data in the memoryLEFT/RIGHT buttons, and then press the Select button ∀, SELECT, Right CLICK, or Point button. To adjust Displayed. Correct the Keystone distortion by pressingMenu P24 This projector cannot display anyVideo I S-Video / Y, PbICb, Pr/Cr Direct OperationMenu Operation Video Signal from Video Jack or S-VIDEO Jack Video Signal from Y, Pb/Cb, Pr/Cr JacksCustom ColorNoise reduction ProgressiveRegular WideBlue back Power off? messageDisplay Remote control Set the Remote control in Setting Menu to ModeTo return to the normal code Mode 1, operate both projector Returns to the normal code ModeInstallation Operating Wireless MouseConnection Not work properlyParticles, it will reduce the Cooling Fans’ Temperature Warning IndicatorAIR Filter Care and Cleaning Lamp Replacement Monitor Timer CoverCleaning ThE Projection Lens Picture is Top/Bottom Reversed Some displays are notSeen during No imageCabinet Dimensions W x H x D Net WeightPanel Resolution Signal Scanning FrequencyMAC Adapter Terminal HDB1 5-PINTerminal DVI 24-pin Terminal Mini DIN 8-PINEiki Deutschland Gmbh