Eiki LC-XC1 owner manual Compliances

Page 4

LC-XC1

COMPLIANCES

Federal Communication Commission Notice

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.

AC POWER CORD REQUIREMENT

The AC Power Cord supplied with this projector meets the requirement for use in the country you purchased it.

AC Power Cord for the United States and Canada:

AC Power Cord used in the United States and Canada is listed by the Underwriters Laboratories (UL) and certified by the Canadian Standard Association (CSA).

AC Power Cord has a grounding-type AC line plug. This is a safety feature to be sure that the plug will fit into the power outlet. Do not try to defeat this safety feature. Should you be unable to insert the plug into the outlet, contact your electrician.

THE SOCKET-OUTLET SHOULD BE INSTALLED NEAR THE EQUIPMENT AND EASILY ACCESSIBLE.

4

Image 4

Contents Model LC-XC1 To the Owner Safety Instructions Compliances Table of Contents Progressive scan signals and provide fine picture quality Projector and computer with this Remote Control Unit onlyIBM-compatible and Macintosh computers up to Color SystemsLC-XC1 Projector side AC Outlet side Positioning the Projector Room LightAdjustable Feet Latches on both sides of the projectorInput Terminals Reset function excessively When using the Wired / WirelessThis projector uses a micro processor to control Refer toLC-XC1 LC-XC1 Indicators Laser Pointer Function Replace Compartment lidFlow of ON-SCREEN Menu Menu BAR Turn the Main on I OFF Switch to ON. The Lamp indicator Turning on the ProjectorTurning OFF the Projector Appliance cannot be turned onZoom Adjustment Focus AdjustmentLens Shift Adjustment Press the Zoom !/∀buttons on the Top Control or onKeystone Adjustment Timer functionPicture Freeze Function ∀button or the Point UP/DOWN buttons. PressDirect Operation Menu OperationTo set the Computer system manually, select the mode on No signalAutomatic MULTI-SCAN System System Menu will appearCompatible Computer Specifications Point UP/DOWN button and the Select button. To Reset Mode free Stored Quit Recalls the data previously adjusted ResetStores the adjusted data in the memory Closes Image MenuNormal Function LEFT/RIGHT buttons, and then press the Select button Setting data in the memoryCloses ∀, SELECT, Right CLICK, or Point button. To adjust Displayed. Correct the Keystone distortion by pressingMenu P24 This projector cannot display anyMenu Operation Direct OperationVideo I S-Video / Y, PbICb, Pr/Cr Video Signal from Video Jack or S-VIDEO Jack Video Signal from Y, Pb/Cb, Pr/Cr JacksCustom ColorNoise reduction ProgressiveRegular WideDisplay Power off? messageBlue back Remote control Set the Remote control in Setting Menu to ModeTo return to the normal code Mode 1, operate both projector Returns to the normal code ModeInstallation Operating Wireless MouseConnection Not work properlyAIR Filter Care and Cleaning Temperature Warning IndicatorParticles, it will reduce the Cooling Fans’ Lamp Replacement Monitor Timer CoverCleaning ThE Projection Lens Picture is Top/Bottom Reversed Some displays are notSeen during No imageCabinet Dimensions W x H x D Net WeightPanel Resolution Signal Scanning FrequencyMAC Adapter Terminal HDB1 5-PINTerminal DVI 24-pin Terminal Mini DIN 8-PINEiki Deutschland Gmbh