JVC BR-HD50E instruction manual Recording index signals

RECORDING

Recording procedure

2. REC button	2. 4. PLAY button
	3. PAUSE
	button

1.Load the cassette tape.

•Before loading the cassette tape, please ensure that the rear slide of the cassette tape is pushed to REC.

The unit is turned on.

2.Start recording.

•Press the PLAY button while holding down the REC button.

3.Pause recording.

•Press the PAUSE button.

4.Resume recording.

•Press the PLAY button.

5.Stop recording.

•Press the STOP button.

5.STOP button

Memo

zThe tape protection function enables BR-HD50 automati- cally to go into the STOP mode when there is a long recording pause. The time to go into the STOP mode can be set with REC LONG P. TIME in the SYSTEM [1/2] Menu screen.

zWhen a home-use DV VCR is used to play tapes record- ed with BR-HD50, the sound level may be reduced.

Recording index signals

If INDEX WRITE is set to ON in the SYSTEM [2/2] Menu screen, an index signal is recorded at the recording starting position of the tape. In the PLAYBACK mode, the position where the index signal is recorded can be searched. (Index search)

„Press the REC button to record index signals during recording.

*It is not possible to record only index signals after the record- ing. Allow at least an interval of 1 minute between recordings of index.

*Index signals cannot be recorded with the REC button of the remote controller. Use the record button of BR-HD50.

Memo

If recording is performed right after the RECORDING PAUSE mode is exited, index signals are not recorded.

E-46