JVC BR-HD50E instruction manual Others, „ Alarm display Displayed regardless of the Display mode

OTHERS

Warning display

When an error occurs, BR-HD50 automatically self-diagnoses the cause and displays an error-coded warning message on the monitor.

If BR-HD50 is not in good order, or if an operation error has occurred, an alarm display will be shown on the monitor.

Warning display Alarm display

D V 3 2 K C H – 1 / 2				S P	6 0 M I N
	WA R N I N G		7 0 0	1
	D R UM MO T O R F A I L U R E
0 6 / 1 4 / 0 5			S T A N D B Y - O F F
1 1 : 2 0 : 0 0		T C R	0 2 : 0 0 : 0 0 : 0 0

D V 3 2 K C H – 1 / 2				S P	6 0 M I N
	H E A D C L E A N I N G R E Q U I R E D !
0 6 / 1 0 / 0 5			S T A N D B Y - O F F
1 1 : 2 0 : 0 0		T C R 0 2 : 0 0 : 0 0 : 0 0

„Alarm display (Displayed regardless of the DISPLAY mode)

Display	Status	Action
LOW VOLTAGE	The DC power voltage is low.	Check the power voltage.
	BR-HD50 will eventually go into the OPERATE
	OFF mode if operation is continued.
HEAD CLEANING	The video head is dirty. (This message is dis-	Clean it with a JVC head-
REQUIRED!	played when the DISPLAY mode is ON or	cleaning tape. (XPage 9)
	AUTO.) If the head is clogged, it will be	If the message persists
	detected and the alarm message will be dis-	despite cleaning, it could be
	played in the PLAYBACK mode. The display	due to bad recording condi-
	disappears when the cassette is ejected or the	tion, defective tape or head
	head gets cleared of clog.	lifespan.
	The message will also disappear when the
	head cleaning tape is loaded.
OVER HEATING!	The internal temperature of BR-HD50 has	Disconnect the power and
	exceeded the stated value.	place BR-HD50 in a cool
		place. If this message is dis-
		played again, the unit may
		have been damaged. In such
		a case, consult your JVC
		authorized dealer.
UNPLUG MAIN	This is a system error that occurs when the	Unplug the power cord from
POWER, PLUG	power is turned on. The OPERATE indicator on	the power outlet and wait for
BACK IN AFTER A	BR-HD50 blinks in green. The unit will not	some time before plugging it
WHILE	accept any operation commands.	back in.

• For alarm displays resulting from operation errors, refer to page 24.

E-79