Arcam DV27 manual Using the remote control, Or the remote control may not work

Using the remote control

CD/DVD	0–9 keypad
Ensure that DVD mode is selected using the CD/DVD toggle	This allows direct access to individual tracks on audio CDs.To select
button.The ‘DVD’ LED above the CD/DVD button is lit briefly	a track, press the corresponding keypad button followed by OK. For
when DVD mode is selected.	tracks greater than 9, enter the digits in sequence. For example, to
	play track 15, press 1, then 5, then OK.

		DISP (display)						Standby
Dims or turns the DV27’s display on or off.Turning the display					CD/DVD REMOTE			Press STANDBY to toggle the standby state of the DVD player.
				CD DVD
off generally gives a slight improvement in sound quality.								Note that Arcam CD players are not controlled by this button.
Pressing DISP once turns the display off; twice dims the display.				CD				CLEAR
To restore the display to full brightness, press DISP a third time.					1	2	3
				DVD				Use CLEAR within the ‘Program’ and ‘Bookmark’ menus to clear a
			A–B	DISP	4	5	6	numeric field (see pages 13–14).
This button enables you to repeat a selected								PROG (program)
	section from the disc (see page 14).
				A-B	7	8	9	You can program a selection of up to 16 chapters/tracks from
			RPT (repeat)	RPT	CLEAR	0	PROG	a disc to play in any order. Press PROG to access the ’Program’
Press RPT to cycle through the repeat play options;								menu (see page 13 and 15).
	alternatively use the ‘Play modes’ menu.							Slow play
Fast play and Skip chapter/tracks								Press	or	on the remote control to play slow forward or
Play fast (	) and Skip (		) chapters/tracks					backwards.There are six speeds of slow playback: 1/7, 1/6, 1/5,
								1/4, 1/3 and 1/2. Press the button repeatedly to cycle through the
	in both directions (see page 10).
								different speeds.To resume normal playback speed, press PLAY.
			OPEN
				OPEN			OK	Note that slow play does not apply to audio CDs.
	Opens and closes the disc tray.
								Cursor pad and OK button
								Use the cursor pad to navigate the On Screen Display (OSD) and
								menu pages. Confirm your selection with the OK button.
							MUTE	MUTE
								Stops sound to the speaker outputs of certain Arcam amplifiers.
		Playback control
Pause (	), Play ( ) and Stop (		) (see page 10).					Volume +/–
Note that when a DVD disc menu is displayed, the
								Adjusts the volume on Arcam remote-controllable amplifiers.
playback controls (including		and	) duplicate the
								Note that the volume (+/–) controls and MUTE button have no
function of the cursor pad and OK button.
								effect on the audio output level of the DVD players.
				P	SUBT	TITLE	MENU
				MODE
		Advanced controls		ZOOM	AUDIO	MEM	RTN
These buttons are described on the next page.
				ANGLE	SETUP	STATUS	SRCH
					CR-314
								NOTE: Remember to install the two AAA batteries
								supplied before trying to use your remote control.
								Do not place anything in front of the FMJ badge on the
								left of the front panel (where the IR receiver is located),
								or the remote control may not work.
						11

English