CyberHome Entertainment 1600 user manual Hello

Problem:

Your screen is empty:

• Many TVs are switched by the DVD recorder to the programme num- ber for the SCART socket by way of a control signal sent through the SCART cable. If the TV does not automatically switch to the SCART socket programme number, manually change to the corresponding programme number on your TV (please refer to the user’s manual of your TV).

• Check that the SCART cable is connected from the TV to the “EXT1 TO TV” (SCART-1)socket on the DVD recorder. The socket “EXT2 AUX” (SCART-2)is intended only for additional devices.

Then, read section “Initial installation” in chapter “Installing your DVD recorder” (see pages 26-27).

20

6 Turn the unit on with the “POWER” button on your remote control or the “STANDBY/ON” button on the front panel of the DVD recorder. “HELLO” appears in the display.

Tips:

“VCR” as the connection source of this SCART socket.

3 Plug the SCART cable into the SCART socket “EXT1 TO TV” (SCART-1)at the back of the DVD recorder and into the corresponding SCART socket of your TV (please refer to the user‘s manual of your TV).

CONNECTING THE DVD RECORDER

EXT1 TO TV

• If your TV has several SCART sockets, please use the SCART sock- et that is suitable for the video output and the video input.

• If your TV offers a menu to choose the SCART socket, please select

4 Turn on the TV.

5 Connect the supplied AC power cord to the “AC IN” socket on the

1 1 back side of the DVD recorder, then plug into a power outlet.

AC IN

7

HELLO

7 If the connection was properly made and your TV was automatically switched to the programme number for the SCART socket, e.g. “EXT”,

Virgin mode 1 / 7 “0”, “AV”, the picture shown on the left side appears.

Before using your recorder, please complete this setup.

Next