CyberHome Entertainment 1600 user manual Connection with S-Video cable

CONNECTING THE DVD RECORDER

HELLO

1 2 3

4

ANTENNA IN

7Turn the unit on with the “POWER” button on your remote control or the “STANDBY/ON” button on the front panel of the DVD recorder. “HELLO” appears in the display.

Then, read section “Initial installation” in chapter “Installing your DVD recorder” (see pages 26-27).

Connection with S-Video cable

If your TV has a S-Video input, it is recommended that you use this video connection. The S-Video connector is distinguishable by its 4 pins. S-Video separates brightness and colour signals, resulting in a higher video quality than standard composite video. For the audio connection you can use the red and white stereo audio in connectors of your TV.

Have the following cables ready:

1.Two aerial cables (not supplied)

2.Power cord (supplied)

3.S-Video cable (not supplied)

4.Audio/video cable - red and white plug (not supplied)

1Connect your antenna/cable TV outlet to the “ANTENNA IN” socket at the back side of your DVD recorder using an aerial cable.

Note:

If your TV is already connected to the antenna/cable TV outlet, remove the aerial cable plug from your TV and insert it into the “ANTENNA IN” socket at the back side of your DVD recorder.

2Insert one end of a second aerial cable into the “ANTENNA OUT” socket at the back of your DVD recorder and the other end into the aer-

ial input socket of your TV.

ANTENNA OUT

S

R L

3Insert one end of the S-Video cable into the socket “S-VIDEO”on the back side of the DVD recorder and the other end in the S-Video input socket of the TV (usually labelled “S-Video in”, "SVHS in”. Please refer to the TV's user manual).

S-VIDEO OUTPUT AUDIO R/L OUTPUT

4Insert the red and white end of the audio/video cable into the red and white cinch socket “AUDIO R/L” on the back side of the DVD recorder and the other end in the (usually red and white) audio input socket of the TV (usually labelled “Audio in”, "AV in”. Please refer to the TV's user manual).

22