Sterling Plumbing scc2 specifications Pump 20-Station Controllers Configurable Settings/Defaults

Page 46

Name	Description	Options	Default
Alarm Options
No convey	When this option is enabled, the controller issues	disabled,	disabled
	a “no convey” alarm if it has repeatedly attempted	enabled
	to convey material to the station but the flapper
	never opened during the dump delay. (The
	number of attempts is controlled by the next
	setting.)
	Usually this option should be enabled. At times,
	you may wish to disable it during operation as a
	stopgap measure for dealing with an alarm.
# attempts before	Number of attempts before alarm: the number of	1–99	3
alarm	times the controller will attempt to convey material
	to a station before it issues a “no convey” alarm.
	The setting for this option depends on (a) how
	much material your injection mold uses to make
	each part compared with the capacity of the
	receiver and (b) how important it is to keep your
	injection mold from running out of material and
	shutting down. A higher setting will give you fewer
	alarms, at the risk of emptying the receiver without
	warning. A lower setting will give more frequent
	alarms, at the risk of disrupting operations
	unnecessarily.

2–Pump 20-Station Controllers

Configurable Settings/Defaults

41 of 51

Image 46

Contents SCC 2-Pump 20-Station Controllers Parts and Service Department Shipping Information Warranty Returns Credit ReturnsTable of Contents Safety Restoring a LOST/CORRUPT PROGRAM...380 How to Use This Manual SafetySafety Symbols Used in this Manual Controller Safety Tags Wear Safety Glasses and Work GlovesSafety Device Lock-Outs Safety Devices and InterlocksSafety Circuit Standards Fail Safe OperationGeneral Responsibility ResponsibilityOperator Responsibility Maintenance Responsibility Reporting a Safety DefectModels Covered in This Manual Standard FeaturesFunctional Description General DescriptionOptional Features Controller FeaturesUncrating InstallationMounting the Control Panel Pump 20 Station Controller with 6 Display Controller Identification Serial Number Tag Located on the side of the controller boxConnecting the Control Panel to the Pump Package Making Control Panel Power Drop Wiring ConnectionsConnecting the Control Panel to Vacuum Hoppers Electrical ConnectionsSetting the Number of Stations and the Number of Pumps Set-upMenu Screen Setting Up Alarm Duration System Setup ScreenSetting Up Pump Staging Setting Up Touch Switch DelaySetting Up Stations Setting Up a Single StationStation Setup Screen Copying Settings from One Station to OthersStation Copy Screen Setting Up Pumps Setting Up a Single PumpPump Setup Screen Copying Settings from One Pump to the OtherPump Copy Screen Setup Password Finishing Setup Setting Up PasswordsOperator Password Page Initial Startup Basic Tasks OperationOverview Reviewing Station StatusReviewing Pump Status Pump Status Screen During OperationPassword Entry Screen Logging On and Logging OffEnabling and Disabling Stations and Pumps Reviewing and Adjusting Basic Station Settings Starting and Stopping the SystemAdjusting Convey Time and Dump Delay Navigating Among the Station Operator ScreensReviewing and Resetting a Pump Hour Meter Adjusting Advanced SettingsActivating and Stopping Priority Convey for a Station Transferring Stations to a Standby Pump Transfer To Standby Pump Screen Standby Pump Errors AlarmsReviewing Alarms Alarm Log Screen Silencing AlarmsRestoring a Lost or Corrupt Program Corrective MaintenancePLC Memory Module Page Configurable Settings/Defaults Station Setup Factory PresetsPump 20-Station Controllers Configurable Settings/Defaults Pump Setup Factory Presets Idle Time OptionsTroubleshooting General TroubleshootingPump Alarms Station AlarmsSystem Alarms Drawings and Diagrams WarrantyAppendix AC Voltage Spare Parts ListDC Voltage Parts Department Service DepartmentTechnical Assistance Contact Information Sales Department