
SECTION
70° and PW93
NOTE: For this procedure, refer to FIGURE 6.4.
1.Remove any accessory from the footrest(s).
2.Remove the footrest from the wheelchair. Refer to Installing/Removing Footrests on page 24.
NOTE: Lay the footrest on a flat surface to simplify this procedure.
3.Remove the mounting screw, washers and locknut that secure the lower footrest assembly to the upper footrest support.
4.Reposition the lower footrest to the desired height.
5.Reinstall the mounting screw, washers and locknut that secure the lower footrest to the footrest support and tighten securely.
6.Repeat STEPS 1‐5 for the opposite wheelchair footrest if necessary.
7.Reinstall the footrest(s) onto the wheelchair. Refer to Installing/ Removing Footrests on page 24.
8.Reinstall any accessory onto the footrest(s).
| Footrest Support | |
Locknut | Coved | |
Washer | ||
| ||
Coved | Mounting Screw | |
Washer | ||
| ||
| Lower | |
| Footrest |
FIGURE 6.4 Adjusting the Footrest Height
- 70° and PW93
70° Taper
NOTE: For this procedure, refer to FIGURE 6.5.
1.Remove any accessory from the footrest(s).
2.Remove the footrest from the wheelchair. Refer to Installing/ Removing Footrests on page 24.
NOTE: Lay the assembly on a flat surface to improve access to the hardware.
NOTE: Note the position of the coved spacers before disassembly.
3.Remove the mounting screw and coved spacer that secures the lower footrest assembly.
4.Position the footrest assembly to the desired height.
5.Secure lower footrest assembly with existing mounting screw and coved spacer. Securely tighten.
Adjustable ASBA Seat | 26 | Part No 1143238 |