Invacare Adjustable ASBA Seat service manual Adjusting the Footplate Depth

Page 36

SECTION 7—POWER ELEVATING LEGRESTS

2.Loosen, but DO NOT remove, the two exterior button screws that secure the footplate assembly to the T‐nuts.

3.Loosen, but DO NOT remove, the two button screws that secure the heel loop to the T‐nuts.

4.Slide footplate assembly up or down, until desired height is achieved.

5.While holding footplate assembly in position, tighten all six button screws that were loosened in STEPS 1‐3.

6.Repeat STEPS 1‐5 for opposite footplate if necessary.

NOTE: If this procedure does not provide enough length, adjust the length of the power legrest. Refer to Adjusting the Length for Power Legrest on page 39.

 

Outside View

Inside View

 

Exterior Rail

 

 

 

Channel

Exterior Rail

 

 

T-Nuts (NOT SHOWN)

 

 

 

 

 

 

Channel

 

 

 

T-Nuts (NOT SHOWN)

 

 

 

 

Button Screws

Exterior

 

 

for Heel Loop

Footplate

 

Interior Button

Button Screws

Footplate Assembly

Assembly

 

Screws

 

 

 

FIGURE 7.2 Adjusting the Footplate Height

Adjusting the Footplate Depth

NOTE: For this procedure, refer to FIGURE 7.3.

1.Remove the two flat head screws and the two barrel nuts that secure the footplate to the footplate clamp.

2.Reposition the footplate on the footplate clamp.

3.Align the desired depth adjustment holes on the footplate to the mounting holes on the footplate clamp.

Flat Head Screws

Depth

Footplate Adjustment

Holes

Footplate Clamp

Mounting Holes

Barrel Nuts

 

FIGURE 7.3 Adjusting the Footplate Depth

4.Insert the barrel nuts through the bottom of the footplate clamp.

5.Install the two flat head screws through the footplate and footplate clamp.

6.Securely tighten with two barrel nuts.

7.Repeat STEPS 1‐6 for opposite footplate if necessary.

Adjustable ASBA Seat

36

Part No 1143238

Image 36
Contents Adjustable Asba Seat Useful Terms Reference DocumentsTable of Contents Arms Adult Seats Junior Seats Signal Word Meaning Special NotesSpecial Notes Label Locations All WheelchairsAll Wheelchairs with Trro Wheelchairs without Trro Adjustable Asba Seat Typical Product ParametersRepair or Service Information General GuidelinesOperation Information Weight Limitation Tire PressureSAFETY/HANDLING of Wheelchairs Pinch PointsEMI Information EMI Information Safety INSPECTION/ Troubleshooting Safety Inspection ChecklistTroubleshooting Center Mount Footrests Removing/Installing the Manual Center Mount Footrest InstallingRemoving Adjusting the Height of the Manual Center Mount Footrest Chairs built before 12/01/2008Chairs built after 12/01/2008 Adjusting the Angle of the Manual Center Mount Footrest Adjusting the Angle of the Manual Center Mount FootrestAdjusting the Footplate Angle Adjusting the Footplate Angle Chairs built before 12/01/2008Adjusting the Tension of the Flip Up Footplate Installing/Removing Footrests Front RiggingsPH904A, PHAL4A, 70 and PW93 Adjusting the Footrest Height TaperPH904A and PHAL4A Front Riggings Adjusting the Footrest Height PW93 PW93Replacing Heel Loops Raising/Lowering Elevating Front RiggingsAdjusting/Replacing Telescoping Front Rigging Support Adjusting/Replacing Telescoping Front Rigging SupportInstalling Adjustable Angle Flip-up Footplate Hinge Installing Adjustable Angle Flip-up FootplatesAdjusting Adjustable Angle Flip-Up Footplates Depth AdjustmentAngle Adjustment Perpendicular and/or Inversion/Eversion AdjustmentReplacing Composite/Articulating Footplate Heel Loop CompositeInstalling/Removing Elevating Legrests 14 Installing/Removing Elevating LegrestsAdjusting Calfpads Raising/Lowering Elevating LegrestsPower Elevating Legrests Installing/Removing the Power Elevating LegrestsInstalling the Power Elevating Legrests Adjusting the Power Elevating Legrests Removing the Power Elevating LegrestsAdjusting the Footplate Adjusting the Footplate Depth Adjusting the Footplate Angle Adjusting the Calf Pad Adjusting the Calf Pad WidthAdjusting the Length for Power Legrest Adjusting the Calf Pad HeightRemoving/Installing the Power Elevating Legrest Harness Removing/Installing the Power Elevating Legrest Actuator Seat frame for clarityRight power Installing/Removing Flip Back Armrests ArmsAdjusting Flip Back Armrests AdjustingPositioning Flip Back Armrests for User Transfer Positioning Flip Back Armrests for UseInstalling/Removing the Cantilever Arms Installing/Removing the Cantilever ArmsAdjusting the Height of the Cantilever Arms Adjusting the Height of the Cantilever ArmsAdjusting the Angle of the Cantilever Arms Installing/Removing the Cantilever Arm ArmpadRemoving/Installing the Contoura Back Installing the Contoura BackAdult Backs Removing the Contoura BackInstalling the Mounting Hardware onto the Contoura Back Removing/Installing the Contoura BackAdjusting the Back Width Adjusting the Back AngleAdjusting the Back Height Removing/Installing the Back CanesRemoving/Installing the Spreader Bar Removing/Installing the Back CanesAdjusting Spreader Bar Width Removing/Installing the Spreader BarAdjusting Spreader Bar Width Junior Backs 100 Non- Trro Back Cane Bracket Mounting Holes Washer Screws Adjusting the Back Height Removing Spreader Bar Cover Mounting Screw Back Cane Tube Mounting Screws Removing/Installing the Seat Pan Adult SeatsAdjusting the Seat Width Side Rail Mounting Holes Adjusting the Seat Width Adjusting the Seat Depth Removing/Installing Side Rails Removing Side RailsInstalling Side Rails Removing/Installing Side RailsJunior Seats Junior Seats To be removed for this procedure To be removed for this Cross BAR Mounting Holes Hex Screw Rear Arm Socket Adjustment Table Inch Limited Warranty USA