SECTION
SECTION 12—JUNIOR SEATS
WARNING
After any adjustments, repair or service and before use, make sure all attaching hardware is tightened securely - otherwise injury or damage may result.
Before performing any maintenance, adjustments or service, ALWAYS turn the wheelchair power off, otherwise injury or damage may result.
Removing/Installing the Seat Pan
NOTE: For this procedure, refer to FIGURE 12.1 on page 70 and FIGURE 12.2 on page 71.
Removing
1.Remove the seat cushion (not shown).
2.12 to 13‐inch Seat Widths Only ‐ Perform the following steps:
A.Note the mounting position of one back cane bracket for reinstallation.
B.Remove the two hex screws, washer, pin and two locknuts securing one back cane bracket to the top of the side rail.
C.Remove the hex screw securing the side of the back cane bracket to the side rail.
D.Loosen, but DO NOT remove, the two hex screws securing the remaining back cane bracket to the top of the side rail.
3.Remove the screws and locknuts securing the seat pan to the seat frame.
NOTE: Wheelchairs with power elevating legrests have two screws (FIGURE 12.1 on page 70) and wheelchairs without power elevating legrests have three screws (FIGURE 12.2 on page 71).
4. Remove the seat pan from the seat frame.
Installing
1. Position the seat pan onto the seat frame.
NOTE: For 12 to 13‐inch seat widths, the seat pan must be positioned between the back cane bracket and the side rail.
Adjustable ASBA Seat | 68 | Part No 1143238 |