SECTION
4.Remove the short shoulder screw and locknut securing the actuator rod to the actuator bracket.
5.Remove the power elevating legrest actuator from the legrest.
Installing
1.Unscrew the actuator rod ½ turn.
2.Secure the actuator rod to the actuator bracket using the short shoulder screw and locknut.
3.Secure the top of the power elevating legrest actuator to the power legrest bracket using the long shoulder screw, flat washer, washer and locknut.
NOTE: The shoulder screw should be on the inside of the legrest and the locknut should be toward the outside of the legrest.
4.Connect the actuator connector (not shown) to the TRECM or DLIAM connector (not shown).
5.Install the power elevating legrest. Refer to Installing/Removing the Power Elevating Legrests on page 34.
Power Legrest Bracket | NOTE: Rear of | |
right power | ||
| ||
Long Shoulder | elevating legrest | |
Screw | shown. Left | |
| legrest actuator | |
Flat Washer | mounts in the | |
| same way. | |
Inside of |
| |
Legrest | Locknut | |
Power Elevating Legrest Actuator | Washer | |
Actuator Rod | Outside of | |
Legrest | ||
Short Shoulder Screw |
| |
| Locknut | |
Actuator Bracket |
|
FIGURE 7.10 Removing/Installing the Power Elevating Legrest Actuator
Adjustable ASBA Seat | 42 | Part No 1143238 |