Invacare Adjustable ASBA Seat Installing the Mounting Hardware onto the Contoura Back

SECTION 9—ADULT BACKS

Installing the Mounting Hardware onto the Contoura Back

1.Secure two of the front mounting brackets to the mounting holes in the Contoura back using two socket screws, four washers and two locknuts. Torque to 75 in‐lbs ± 20%.

2.Loosely attach the remaining two front mounting brackets to the slots in the Contoura back using two socket screws, four washers and two locknuts.

NOTE: The two socket screws and locknuts will be tightened when the Contoura back is installed onto the back canes.

3. Install the Contoura back. Refer to Installing the Contoura Back on page 48.

Contoura Back

Back Cane

Washer

Locknuts

Socket

Screw*

Rear

Mounting

Bracket

Mounting

Screw

Socket

Screw*

Lower Front

Mounting Bracket

Back Cane

Upper Front

Mounting Bracket

Mounting Socket

Screw Screws*

Washer

Lower Front

Mounting Bracket

Washer

Socket

Screws**

Washer

*NOTE: Remove these socket screws when removing the back from the back canes.

**NOTE: Remove these socket screws when removing the hardware from the back.

FIGURE 9.1 Removing/Installing the Contoura Back

Part No 1143238 49 Adjustable ASBA Seat