
SECTION
Adjusting the Height of the Cantilever Arms
NOTE: For this procedure, refer to FIGURE 8.4.
1.Adjust the angle of the cantilever arms to allow access to the hardware that attaches the mounting brackets to the back canes. Refer to Adjusting the Angle of the Cantilever Arms.
2.Loosen the three screws that secure the back cane mounting bracket to the back cane. Repeat to loosen the opposite back cane mounting bracket.
3.Adjust the position of mounting brackets and spreader bar up or down the back cane to desired height.
4.Tighten the screws on both back cane mounting brackets to secure the back cane mounting brackets at the desired height obtained in STEP 3.
5.Adjust the angle of the cantilever arms to accommodate the user. Refer to Adjusting the Angle of the Cantilever Arms on page 47.
Adjust angle of Cantilever Arm
(STEP 1)
Back Cane Mounting Bracket
Screws (STEP 2)
FIGURE 8.4 Adjusting the Height of the Cantilever Arms
Adjustable ASBA Seat | 46 | Part No 1143238 |