SECTION
Adjusting the Footplate Angle
NOTE: For this procedure, refer to FIGURE 7.4.
1.Loosen, but DO NOT remove, the two flat head screws and the two barrel nuts that secure the footplate to the footplate clamp (Detail “A”).
2.Rotate the footplate clamp on the pivot hinge until the desired angle is achieved (Detail “B”).
3.Securely tighten footplate to footplate clamp and hinge pivot with the two flat head screws and barrel nuts.
4.Repeat STEPS 1‐3 for opposite side if necessary.
5.For additional angle adjustment, perform the following (Detail “C”):
A.Loosen the set screw.
B.Rotate footplate up or down to desired position.
C.Retighten set screw.
DETAIL “A”
Flat Head
Screws Footplate
Footplate
Clamp
Barrel Nuts
DETAIL “B”
Footplate
Footplate | Pivot Hinge |
Clamp |
Part No 1143238 | 37 | Adjustable ASBA Seat |