Invacare Adjustable ASBA Seat service manual Adjusting the Length for Power Legrest

SECTION 7—POWER ELEVATING LEGRESTS

7.Align the two T‐nuts on depth adjustment bracket assembly with channel on legrest. Slide calf pad assembly to desired height. Tighten the two hex screws securely.

8.Repeat STEPS 1‐6 for opposite side.

Adjusting the Calf Pad Height

NOTE: For this procedure, refer to FIGURE 7.7.

1.Loosen, but DO NOT remove, the two hex head screws that secure depth adjustment bracket to the T‐nuts.

2. Slide the calf pad assembly with T‐nuts up or down in the channel to desired position.

3. Holding the calf pad assembly in position, tightly secure the hex screws to the T‐nuts.

4. Repeat STEPS 1‐3 for opposite side if necessary.

Hex Head

Screws (T-Nuts are not shown)

Depth

Adjustment

Bracket

Channel

Outer Rail

FIGURE 7.7 Adjusting the Calf Pad Height

Adjusting the Length for Power Legrest

NOTE: For this procedure, refer to FIGURE 7.8.

1. Loosen, but DO NOT remove, the button screw (screw also secures lower end of shroud).

2. Slide footplate with outer cover up or down to desired position.

3. Securely tighten button screw.

4. Repeat STEPS 1‐3 for remaining legrest.

Button

Screw

NOTE: Length adjustment is from 15½ ‐ 20 inches.

Outer

Cover

FIGURE 7.8 Adjusting the Length for

Power Legrest

Part No 1143238 39 Adjustable ASBA Seat