SECTION
CAUTION
Make sure coved spacers are positioned properly when reassembling to prevent damage to the frame mounting tubes.
6.Reinstall the footrest(s) onto the wheelchair. Refer to Installing/Removing Footrests on page 24.
7.Reinstall any accessory onto the footrest(s).
Replacing Heel Loops
NOTE: For this procedure, refer to FIGURE 6.6.
1.Note the position of hex bolt, coved washers and locknut for reinstallation.
2.Remove the hex bolt, coved washers and locknut that secure the lower footrest to the footrest support.
3.Remove the lower footrest.
4.Remove the phillips bolt, spacer and locknut that secure the heel loop to the lower footrest.
5.Slide the heel loop off the lower footrest.
6.Replace heel loop.
7.Reverse STEPS 1‐6 to reassemble.
NOTE: When securing heel loop to lower footrest, tighten the phillips bolt and locknut until the spacer is secure.
| Footrest Support | |
Locknut | Hex Bolt | |
Phillips Bolt | ||
Coved | ||
Spacer | ||
Washer | ||
| Heel | |
Lower Footrest | Loop | |
| ||
| Locknut |
FIGURE 6.6 Replacing Heel Loops
Raising/Lowering Elevating Front Riggings
NOTE: For this procedure, refer to FIGURE 6.7.
1.Perform one of the following:
•Raising ‐ Pull back on the release lever and raise front rigging to the desired height.
•Lowering ‐ Support front rigging with one hand away from the release lever. Push release lever downward with other hand.
ReleasePart No 1143238 | 27 | Adjustable ASBA Seat |