SCE4430 17-09-2007 13:29 Pagina 5
ENGLISH
6 Technical specifications
•Battery type: Lithium polymer
•Rated input: 5V DC, max. 500 mA
•Rated output: 5.6V DC, max. 350 mA
•Battery capacity: 2000 mAh
•Recharging time: 4.5 - 6.5 hours
•Operating temperature: 0ºC - 45ºC
•Size: 60 x 87 x 16 mm (h x w x d)
•Weight: 88 g
7 Troubleshooting
Problem
–Possible cause
• Solution
The power pack does not charge connected device
–Voltage of device does not correspond with that of power pack.
•Refer to the user manual that came with the device.
– Improper connection between device and power pack.
•Check that connection cord is properly inserted into both device and power pack.
– Damaged connection cable or connector tip.
•Replace connection cable or connector tip.
– Wrong connector tip used.
•Check connector tip and replace if necessary.
– Non supplied USB connection cable/connector tip used.
•Replace with supplied USB connection cable/connector tip.
–Battery power of power pack too low.
• Charge power pack.
–Problems with electrical circuit of power pack.
• Take the power pack to your local distributor.
–Short circuit occurred in the power pack and the power pack protection function switched off the power pack.
• Charge power pack.
– Problems with electrical circuit of power pack.
• Take the power pack to your local distributor.
Power pack runs out of power quickly
–Power pack not fully charged before using.
• Fully charge power pack before using.
–Supplied AC power adapter was not used for charging power pack.
•Only use supplied AC power adapter for charging power pack.
Power pack cannot be charged
–Improper connection between power pack and wall outlet.
• Check that power cord is properly inserted into both wall outlet and AC power adapter.
• Check that adapter plug is properly inserted into the INPUT 5V DC Jack of the power pack.
–Problems with the electrical circuit of the power pack.
• Take the power pack to your local distributor.
Note:
If you are unable to solve a problem by following the above hints, try resetting the power pack by pressing RESET.The RESET button is recessed to prevent accidental reset of the power pack. Use a paperclip to gently press the RESET button (see fig. D).
8 Maintenance
•Recharge the power pack every three months when it is not being used for a long period of time.
•Use a soft,
•When any problems occur with the power pack or the accessories, take the adapter and accessories to your local distributor.
9 Need help?
Online help: www.philips.com/welcome
For interactive help and frequently asked questions.
5