JVC TK-C655 manual Duplex, Four wires must be connected, For example connection with an RM-P2580

Page 11

Use twisted-pair cables for the connections.

●Duplex

When the camera is controlled using the full duplex trans- mission protocol, set Switch 5 to OFF.

Camera	Controller
RX+	TX+
RX–	TX–
TX+	RX+
TX–	RX–

Four wires must be connected.

For example (connection with an RM-P2580)

Camera	RM-P2580
RX+ C	C TX+
RX– D	D TX–
TX+ A	A RX+
TX– B	B RX–

●Simplex

When the camera is controlled using the simplex trans- mission protocol, set Switch 5 to ON.

Camera	Controller
RX+	TX+
RX–	TX–

Two wires must be connected.

Image 11

Contents TK-C655 Important Safeguards Contents Safety Precautions FeaturesProvided Accessories Zooming Precautions for Correct Operation Preset positions Camera setups with which auto focusing may be difficult Ceiling Mount Controls, Connectors and Indicators Ceiling Mount Camera Cable connections P Switch settings PMulti-Drop Communication System Memo Point-to-Point Communication System Turn all the components power off before proceedingConnector side of the Ceiling Mount Switch 7 OFF Switch 8 onFor example connection with an RM-P2580 Four wires must be connectedTwo wires must be connected Duplex Setting switches Switch SettingsExample Camera ID check procedureMachine ID Bers on the RM-P2580Pass the cables through the cover Cable ConnectionsMake a 90 mm diameter hole in the ceiling Remove the cover from the Ceiling MountCoaxial cable Control signal cablesAttach the cover Attaching the Camera Attaching a safety wireAttach the drop prevention wire Attaching the Ceiling MountRotate the camera Tighten the lock screw using a Phillips screwdriverEnsure that the locking screw is loose Fit the cameraPress the SET button Setup ProcedureSetting the camera menus from an RM-P2580 Press and hold the Menu button for 3 secondsNormal screen Menu Screen FlowCamera Function Screen Camera TITLE/ALARM Screen Camera ALC/ExDR screen Camera Video Adjustment ScreenSense UP AGC ModePosition Function SET Screen Auto PAN/PATROL/TRACE ScreenFactory Settings screen Private Mask Setup Repeat steps 5 and 6 for each title character Camera Title SetupPress the Tele button Repeat steps 5 to 7 for each area title Area Title SetupMove the cursor to Area Title Edit and press the SET button Press the FAR buttonRepeat steps 5 to 7 for each alarm title Alarm Title SetupDisplay the Setup menu on the camera Adjust the viewing angle of the start position Auto PAN SetupSet the auto pan mode and speed Auto Patrol Setup Auto Trace SET screen is displayed Auto Trace SetupMove the cursor to Autotrace SET and press the SET button Set the patrol start positionPosition Title screen Position Title SetupRepeat steps 5 to 7 for each title character Position Function SET screenCeiling plate Attaching a Flush Mounted Ceiling Bracket Optional WB-S575Clamp the Flush Mounted Ceiling Bracket IngConnection Cables Attach the ceiling panelCheck the release labels thoroughly before removal Removing a Flush Mounted Ceiling Bracket Optional WB-S575Remove the ceiling panel Remove the cameraSymptom Cause Information Remedy TroubleshootingGeneral SpecificationsCamera Pan/Tilt MechanismWB-S575 Flush Mounted Ceiling Bracket + Ceiling panel External dimensions Unit mmDimensions in combination with the WB-S575 Ceiling Mount holeTK-C655 Dome Type Camera