JVC TK-C655 manual Point-to-Point Communication System, Connector side of the Ceiling Mount

Page 10

Connections & Installation

Point-to-Point Communication System

The following illustration shows a system in which a remote control unit (or a similar piece of equipment) controls a single camera.

Video out

Control signal cable

AC 24 V power supply

Switch 4 : OFF (Point to Point) Switch 8 : ON (Terminated 110)

Observe the following points when connecting system components :

Turn all the components power off before proceeding.

Read the instruction manuals of each component before above proceeding.

Monitor

Controller

Cable connections P. 14

(Connector side of the Ceiling Mount)

Control signal cable

To controller

Coaxial cable

To monitor

To the AC 24V power supply

Power cable

Switch settings P. 12

(Setting switches on the Ceiling Mount: Setting switch side)

Setting not required

1

2

3

4

5

6

7

8

F

F

O

Switch 1 : OFF

Switch 2 : OFF

Switch 4 : OFF

Switch 5 : Configure in accordance with the requirements of the controller communication system.

Switch 7 : OFF

Switch 8 : ON

MEMO

If this camera or the cables connected to this camera are used in places subject to strong electromagnetic waves or other forms of magnetism, for example near a radio or TV transmitter, a power transformer or an electric motor, the picture may suffer from noise and colours may be affected.

In order to operate and control the TK-C655 camera, a separate control unit accessory is required. Please contact JVC author- ized dealer or installer for more information about these controllers.

10

Image 10
Contents TK-C655 Important Safeguards Contents Provided Accessories FeaturesSafety Precautions Camera setups with which auto focusing may be difficult Precautions for Correct Operation Preset positions  ZoomingControls, Connectors and Indicators  Ceiling Mount Ceiling Mount  Camera Multi-Drop Communication System Switch settings PCable connections P Memo Switch 7 OFF Switch 8 on Turn all the components power off before proceedingConnector side of the Ceiling Mount Point-to-Point Communication SystemDuplex Four wires must be connectedTwo wires must be connected For example connection with an RM-P2580Switch Settings  Setting switchesBers on the RM-P2580 Camera ID check procedureMachine ID ExampleRemove the cover from the Ceiling Mount Cable ConnectionsMake a 90 mm diameter hole in the ceiling Pass the cables through the coverAttach the cover Control signal cablesCoaxial cable Attaching the Ceiling Mount Attaching a safety wireAttach the drop prevention wire Attaching the CameraFit the camera Tighten the lock screw using a Phillips screwdriverEnsure that the locking screw is loose Rotate the cameraPress and hold the Menu button for 3 seconds Setup ProcedureSetting the camera menus from an RM-P2580 Press the SET buttonMenu Screen Flow Normal screenCamera Function Screen Camera TITLE/ALARM Screen Camera Video Adjustment Screen Camera ALC/ExDR screenAGC Mode Sense UPAuto PAN/PATROL/TRACE Screen Position Function SET ScreenFactory Settings screen Private Mask Setup Press the Tele button Camera Title SetupRepeat steps 5 and 6 for each title character Press the FAR button Area Title SetupMove the cursor to Area Title Edit and press the SET button Repeat steps 5 to 7 for each area titleDisplay the Setup menu on the camera Alarm Title SetupRepeat steps 5 to 7 for each alarm title Set the auto pan mode and speed Auto PAN SetupAdjust the viewing angle of the start position Auto Patrol Setup Set the patrol start position Auto Trace SetupMove the cursor to Autotrace SET and press the SET button Auto Trace SET screen is displayedPosition Function SET screen Position Title SetupRepeat steps 5 to 7 for each title character Position Title screenIng Attaching a Flush Mounted Ceiling Bracket Optional WB-S575Clamp the Flush Mounted Ceiling Bracket Ceiling plateAttach the ceiling panel Connection CablesRemove the camera Removing a Flush Mounted Ceiling Bracket Optional WB-S575Remove the ceiling panel Check the release labels thoroughly before removalTroubleshooting Symptom Cause Information RemedyPan/Tilt Mechanism SpecificationsCamera GeneralCeiling Mount hole External dimensions Unit mmDimensions in combination with the WB-S575 WB-S575 Flush Mounted Ceiling Bracket + Ceiling panelTK-C655 Dome Type Camera