JVC TK-C655 Removing a Flush Mounted Ceiling Bracket Optional WB-S575, Remove the ceiling panel

Page 36

Other

Removing a Flush Mounted Ceiling Bracket (Optional WB-S575)

3.

<Check the release labels thoroughly before removal.>

1. Remove the ceiling panel.

Pull down the ceiling panel and disengage the two hooks either side.

2. Remove the camera.

Clamping bracket

Remove the camera from the Ceiling Mount by reversing the attach- ing procedure.

P. 16, “Attaching the Camera”

4.

Stoppers

3. Loosen the clamping screws of the Flush Mounted Ceiling Bracket.

Loosen the three clamping screws (by turning them anti-clock- wise).

Make sure that the clamping brackets move inwards.

5.

Release label

6.

*

Push the stopper release lever upwards with a screwdriver, etc.

4. Lower the Flush Mounted Ceiling Bracket until the stoppers contact the ceiling plate.

5. Push up the stopper release lever, marked (*) in the figure, using a screwdriver.

While holding the Flush Mounted Ceiling Bracket from below so that it does not drop, push up the one of the three stopper release levers marked (*)using a screwdriver or a similar tool.

If the ceiling plate is thick and the stoppers cannot be released easily, push up two of the stopper release levers (including the one marked (*)).

6.Pull out the Flush Mounted Ceiling Bracket from the hole in the ceiling.

Tilt the Flush Mounted Ceiling Bracket and move it obliquely down- wards to remove it.

36

Image 36
Contents TK-C655 Important Safeguards Contents Features Provided AccessoriesSafety Precautions Precautions for Correct Operation  Preset positionsCamera setups with which auto focusing may be difficult  ZoomingControls, Connectors and Indicators  Ceiling Mount Ceiling Mount  Camera Switch settings P Multi-Drop Communication SystemCable connections P Memo Turn all the components power off before proceeding Connector side of the Ceiling MountSwitch 7 OFF Switch 8 on Point-to-Point Communication SystemFour wires must be connected Two wires must be connectedDuplex For example connection with an RM-P2580Switch Settings  Setting switchesCamera ID check procedure Machine IDBers on the RM-P2580 ExampleCable Connections Make a 90 mm diameter hole in the ceilingRemove the cover from the Ceiling Mount Pass the cables through the coverControl signal cables Attach the coverCoaxial cable Attaching a safety wire Attach the drop prevention wireAttaching the Ceiling Mount Attaching the CameraTighten the lock screw using a Phillips screwdriver Ensure that the locking screw is looseFit the camera Rotate the cameraSetup Procedure Setting the camera menus from an RM-P2580Press and hold the Menu button for 3 seconds Press the SET buttonMenu Screen Flow Normal screenCamera Function Screen Camera TITLE/ALARM Screen Camera Video Adjustment Screen Camera ALC/ExDR screenAGC Mode Sense UPAuto PAN/PATROL/TRACE Screen Position Function SET ScreenFactory Settings screen Private Mask Setup Camera Title Setup Press the Tele buttonRepeat steps 5 and 6 for each title character Area Title Setup Move the cursor to Area Title Edit and press the SET buttonPress the FAR button Repeat steps 5 to 7 for each area titleAlarm Title Setup Display the Setup menu on the cameraRepeat steps 5 to 7 for each alarm title Auto PAN Setup Set the auto pan mode and speedAdjust the viewing angle of the start position Auto Patrol Setup Auto Trace Setup Move the cursor to Autotrace SET and press the SET buttonSet the patrol start position Auto Trace SET screen is displayedPosition Title Setup Repeat steps 5 to 7 for each title characterPosition Function SET screen Position Title screenAttaching a Flush Mounted Ceiling Bracket Optional WB-S575 Clamp the Flush Mounted Ceiling BracketIng Ceiling plateAttach the ceiling panel Connection CablesRemoving a Flush Mounted Ceiling Bracket Optional WB-S575 Remove the ceiling panelRemove the camera Check the release labels thoroughly before removalTroubleshooting Symptom Cause Information RemedySpecifications CameraPan/Tilt Mechanism GeneralExternal dimensions Unit mm Dimensions in combination with the WB-S575Ceiling Mount hole WB-S575 Flush Mounted Ceiling Bracket + Ceiling panelTK-C655 Dome Type Camera