JVC TK-C655 manual Attaching a Flush Mounted Ceiling Bracket Optional WB-S575, Ing, Ceiling plate

Page 34

Other

Attaching a Flush Mounted Ceiling Bracket (Optional WB-S575)

The Flush Mounted Ceiling Bracket (optional WB-S575) allows the camera to be installed flush with the ceiling surface. In this case the ceiling material should have a thickness of between 5 mm and 31 mm.

Mounting hole

3 positions

Anchor bolt mount holes

Clamping screw

Loosen

Clamping bracket

Clamping screw

Clamping screw

Mounting screws (x 4)

(1)

1. Make a hole (diameter 200 mm) in the ceiling.

2. Prepare the Flush Mounted Ceiling Bracket.

•Fully loosen the clamping screws (by turning them anti-clockwise).

•Move the clamping brackets towards the inside as shown in the diagram.

•Remove the four mounting screws.

3. Clamp the Flush Mounted Ceiling Bracket.

(1)	Fit the Flush Mounted Ceiling Bracket into the hole in the ceil-
	ing.
Clamping screw
(2)	Ensure that the stoppers are pressing against the back of the
(2)	ceiling plate.

Stoppers

Anchor bolt mount

(3) Push the Flush Mounted Ceiling Bracket all the way up and tight- en the three clamping screws (by turning them clockwise).

(3)

CAUTION

• Make sure that the clamping brackets grip the ceiling plate firmly.

• If the Flush Mounted Ceiling Bracket rattles after the clamping screws are tightened, loosen them fully and tighten them again.

If anchor bolts can be used, attach them using M8 - M10 (or 3/8 inch) nuts.

34

Image 34

Contents TK-C655 Important Safeguards Contents Provided Accessories FeaturesSafety Precautions Camera setups with which auto focusing may be difficult Precautions for Correct Operation Preset positions ZoomingControls, Connectors and Indicators Ceiling Mount Ceiling Mount Camera Multi-Drop Communication System Switch settings PCable connections P Memo Switch 7 OFF Switch 8 on Turn all the components power off before proceedingConnector side of the Ceiling Mount Point-to-Point Communication SystemDuplex Four wires must be connectedTwo wires must be connected For example connection with an RM-P2580Switch Settings Setting switchesBers on the RM-P2580 Camera ID check procedureMachine ID ExampleRemove the cover from the Ceiling Mount Cable ConnectionsMake a 90 mm diameter hole in the ceiling Pass the cables through the coverAttach the cover Control signal cablesCoaxial cable Attaching the Ceiling Mount Attaching a safety wireAttach the drop prevention wire Attaching the CameraFit the camera Tighten the lock screw using a Phillips screwdriverEnsure that the locking screw is loose Rotate the cameraPress and hold the Menu button for 3 seconds Setup ProcedureSetting the camera menus from an RM-P2580 Press the SET buttonMenu Screen Flow Normal screenCamera Function Screen Camera TITLE/ALARM Screen Camera Video Adjustment Screen Camera ALC/ExDR screenAGC Mode Sense UPAuto PAN/PATROL/TRACE Screen Position Function SET ScreenFactory Settings screen Private Mask Setup Press the Tele button Camera Title SetupRepeat steps 5 and 6 for each title character Press the FAR button Area Title SetupMove the cursor to Area Title Edit and press the SET button Repeat steps 5 to 7 for each area titleDisplay the Setup menu on the camera Alarm Title SetupRepeat steps 5 to 7 for each alarm title Set the auto pan mode and speed Auto PAN SetupAdjust the viewing angle of the start position Auto Patrol Setup Set the patrol start position Auto Trace SetupMove the cursor to Autotrace SET and press the SET button Auto Trace SET screen is displayedPosition Function SET screen Position Title SetupRepeat steps 5 to 7 for each title character Position Title screenIng Attaching a Flush Mounted Ceiling Bracket Optional WB-S575Clamp the Flush Mounted Ceiling Bracket Ceiling plateAttach the ceiling panel Connection CablesRemove the camera Removing a Flush Mounted Ceiling Bracket Optional WB-S575Remove the ceiling panel Check the release labels thoroughly before removalTroubleshooting Symptom Cause Information RemedyPan/Tilt Mechanism SpecificationsCamera GeneralCeiling Mount hole External dimensions Unit mmDimensions in combination with the WB-S575 WB-S575 Flush Mounted Ceiling Bracket + Ceiling panelTK-C655 Dome Type Camera