Sony BRC-Z330 To assign camera addresses automatically, To assign camera addresses manually

To assign camera addresses automatically

1 Make sure that the camera address selector on the bottom of each camera is set to “0.”

For setting the camera address selector, see page 14.

2 Turn on the power of all the connected cameras and the RM-BR300 Remote Control Unit.

3 Hold down the RESET button and press the POWER button on the Remote Control Unit.

The Remote Control Unit recognizes the connected cameras and assigns them camera addresses 1 to 7 automatically in the connected order.

4 Press the POWER button on the Remote Control Unit and check that the CAMERA buttons light. The number of the lit CAMERA buttons indicates how many cameras have the addresses assigned. Now you can switch the camera you want to control with the Remote Control Unit by pressing the CAMERA button.

To assign camera addresses manually

Set one of the camera addresses, 1 to 7, using the camera address selectors on the bottom of each camera.

For setting the camera address selectors, see page 14.

Pan/Tilt and Zoom

Operation

Panning and Tilting

L/R DIRECTION						REV
			1STD							PAN-TILT RESET
	VALUE	LOCK			PANEL	BLACK PAN-TILT		ONE PUSH
					LIGHT	LIGHT	RESET		AWB		MENU
			RESET
–	+
	R		PRESET			POSITION
		MODE
	BRIGHT
			SHIFT	1	2	3	4	5	6	7	8
				9	10	11	12	13	14	15	16
–	+		L/R	STD	REV
	B		DIRECTION			CAMERA
		AUTO
	FOCUS	AUTO	POWER	1	2	3	4	5	6	7
		MANUAL
		ONE PUSH
NEAR FAR		AF
POWER			SHIFT					2			3

1 Turn on the power of the camera and the RM- BR300 Remote Control Unit.

The camera will turn on, performing the pan/tilt reset action automatically.

2 Press the CAMERA button corresponding to the camera you want to operate.

3 Operate the joystick to pan or tilt the camera. While checking the picture on the screen, incline the joystick in the desired direction.

The panning/tilting speed changes according to the angle at which you incline the joystick.

Release the joystick to stop panning/tilting.

To set a limit on the maximum panning/ tilting speed

You can limit the panning/tilting speed obtained when you incline the joystick at the maximum angle.

1 Hold the PAN-TILT RESET button for more than a second while pressing the SHIFT button.

All of the CAMERA buttons 1 to 7 flash.

2 Press the CAMERA button corresponding to the speed you want to set, as shown in the table below.

CAMERA button Maximum panning/tilting

speed

1	4.4 degrees/sec.
2	6.7 degrees/sec.
3	11.6 degrees/sec.
4	18.6 degrees/sec.
5	29.2 degrees/sec.

Operation Using the RM-BR300 Remote Control Unit

Pan/Tilt and Zoom Operation

37