Configure the settings relating to the NTP server [NTP]
Click the [NTP] tab on the "Basic setup" page. (☞ page 15)
The settings relating to the NTP server such as the NTP server address, port number, etc. can be configured on this page.
[Time adjustment]
Select the time adjustment method from the following. Time adjusted by the selected method will be used as the standard time of the camera.
Manual setup: Time set on the [Basic] tab on the "Basic setup" page will be used as the standard time of the camera.
Synchronization with NTP server: Time automatically adjusted by synchronizing with the NTP server will be used as the standard time of the camera.
Default: Manual setup
[NTP server address]
Enter the IP address or the host name of the NTP serv- er.
Number of characters for the NTP server address:
1 - 128 characters Default: None (blank)
[NTP port]
Enter a port number to be used for the NTP server. Available port number: 1 - 65535
Default: 123
[Synchronization interval]
Select an interval (1 - 24 hours: in 1 hour intervals) of synchronization with the NTP server.
Default: 1 hour
[Time zone]
Select a time zone corresponding to the location where the camera is in use.
Default: (GMT) Greenwich Mean Time: Dublin, Edinburgh, Lisbon, London
Important:
When entering the host name for "NTP server address", it is necessary to configure the DNS set- tings on the [Network] tab of the "Network setup" page. (☞ page 59)
21