Configuring the network settings [Network setup]
The network settings and the settings relating to DDNS (Dynamic DNS) and SNMP (Simple Network management Protocol) can be configured on this page.
The "Network setup" page has 4 tabs; the [Network] tab, the [DDNS] tab, the [SNMP] tab and the [FTP] tab.
Configure the network settings [Network]
Click the [Network] tab on the "Network setup" page. (☞ page 15)
The following information is required to configure the network settings.
Contact the network administrator or your Internet service provider.
•IP address
•Net mask
•Default gateway (when using the gateway server/router)
•HTTP port
•Primary DNS, Secondary DNS (when using DNS)
<Unavailable IP addresses>
0.*.*.* *.*.*.0
255.*.*.* *.*.*.255 127.0.0.1
Class D addresses (224.0.0.0 - 239.255.255.255) Class E addresses (240.0.0.0 - 255.255.255.255)
Note:
These IP addresses are unavailable even when using the DHCP function. Refer to the network administrator for further information about the set- tings of the DHCP server.
■Network setup
[DHCP]
Select "ON" or "OFF" to determine whether or not to use the DHCP function.
Configure the DHCP server not to assign the same IP addresses used for the other network cameras and PCs whose IP address is unique. Refer to the network administrator for further information about the settings of the server.
Default: OFF
[IP address]
When not using the DHCP function, enter the IP address of the camera. Do not enter an IP address already in use (for the PCs and the other network cam- eras).
Default: 192.168.0.10
[Net mask]
When not using the DHCP function, enter the net mask of the camera.
Default: 255.255.255.0
58